($222.90) £222.90 exc vat
($267.48) £267.48 inc vat
In stock
Instrument pack wires require use of your old wiring block.
($222.90) £222.90 exc vat
($267.48) £267.48 inc vat
In stockRecommended usage 1 x HAM1200 to fit one mini.
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
Plug and fly loom for later 2/3 clock speedos, useful if you are converting from a centre speedo to later clocks or just repairing a standard loom.
Rear body harness with speaker wires, known as thick wall type which was replaced by thin wall PVC covered wire type in 1989. AN169 is the thin wall equivalent and occassionly fitted or found on early cars wothout any problems.
...
All Minis require an earth strap from the engine to the body and from 1959-1996
they fitted from the gearbox to the subframe. When they introduced the twin point in 1996 it was moved to the upper engine stabiliser arm. About 13"LONG.
When replacing the 520160A parking switch the inner contact areas on the wiring loom are also worn or damaged so we produced this socket and small length of loom.
Universal post type battery earth strap with clamp type fitting and correct length for most alternatives of batteries fitted.
The battery cover made of a special cardboard as fitted to all minis to protect
the battery terminals from metal objects. See also the 14A7666 retaining strap.
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
The only battery cable to run the full length of the Mini, this has a positive type terminal that clamps arond the post rather than the helmet or cap type on much earlier cars. Some cars had slightly shorter cables than this but measure your old cabl...
Basically just the rear lamps and number plate lamp wiring loom for mini van.
PVC covered rear loom only for Mk2 with heated rear screen.
Can be fitted to MK3 front loom ( HAM2174 ).
Large grommet to fit 1"approx holes in bulkhead for items that need to be able to flex and move such as capillary tubes and oil pipes. 7/32" hole size.
The small hole will expand and is also used as wiring loom through bulkhead and battery c...
This plug fits the hole in the inner wing where the wiring for the wing side repeater lamp goes through the body on cars after 1986.
Screw for holding PRC1230A to the number plate light body, 1970 onwards.
Plastic holder for the later flasher unit GFU2218. Needs to be mounted to the bulkhead prior to fitting the flasher unit to the holder
INDICATOR LAMP WITH WHITE LENS AND LED BULBS. sold singly,2 required per car
Best on the market, sports coil-Not Lucas. A standard coil can only do so much, and when compression is raised (as in most high performance engines) or improper fuel mixtures occur something better is needed. This sports gold coil with proven origina...
Single bullet connector used to join the front loom to the rear loom near the wiper motor.
Double bullet connector used to join the front loom to the rear loom enar the wiper motor.
Foam gasket that goes between the indicator/side lamp unit and front panel for all clubman models
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.