OXYGEN SENSOR LAMBDA UNIT (SPi & MPi) BOSCH

MHK10004BOSCH

($78.57) £78.57 exc vat

($94.28) £94.28 inc vat

In stock

Genuine Bosch lambda sensor, fitted to both the twin and single point injection cars and fitted in the same exhaust manifold shared by both cars. Be warned the cheaper non branded sensors cause lots of issues hence we only sell the Bosch version.

($78.57) £78.57 exc vat

($94.28) £94.28 inc vat

In stock

Recommended usage 1 x MHK10004BOSCH to fit one mini.

People also bought products

GROMMET FOR WIRING LOOM through dash or bulkhead

3H1457

Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.

($1.50) £1.50 exc vat

($1.80) £1.80 inc vat

INTERIOR LAMP MK1 POINTED ENDS

14A9148

Interior lamp with a black on/off switch and pointed torpedo ends.

Also fitted many of the 1959on range of Austin A55/60 Cambridge, MG Magnette etc.

Also there was an alternative lamp with black switch and square ends 13H192 which w...

($28.00) £28.00 exc vat

($33.60) £33.60 inc vat

DISTRIBUTOR HOLE BLANKING PLUG A+

DIZZYPLUG02

Lightweight billet aluminium distributor hole blanking plug for A+ engines.

($17.50) £17.50 exc vat

($21.00) £21.00 inc vat

VICTOR REINZ SMALL BORE HEAD GASKET

GUG702506VR

Victor Reinz/Mahle small bore head gasket for A-series engines.

Gasket fitment. Writing side up.

($10.40) £10.40 exc vat

($12.48) £12.48 inc vat

DIP SWITCH LEAD LHD

3102

Dip switch lead for left hand drive cars, these are not included with new looms.

($9.60) £9.60 exc vat

($11.52) £11.52 inc vat

11/16" DOWTY SEAL

DSM18

11/16" dowty seal for post 1991 cars where the original pipe has been replaced with a braided pipe or an oil cooler has been fitted using part number MOC4. used on the TCZ102

($2.40) £2.40 exc vat

($2.88) £2.88 inc vat

PUROLATER FILTER BOWL TO HEAD SEAL

12A1591

This is the large seal for the early type oil filter assembly pre spin on type.

($3.00) £3.00 exc vat

($3.60) £3.60 inc vat

SINGLE PISTON RING SET FOR R41570-00

08-524100-00

($18.75) £18.75 exc vat

($22.50) £22.50 inc vat

SWIFTUNE PERFORMANCE DIE CAST PISTON SET 1275 +40

C-STN103-40

These Swiftune die cast performance pistons are part of their new Heritage range and are manufactured by global leading F1 German piston manufacturer Mahle. These pistons have been developed using their 50 plus years of experience. Glyn Swift was usi...

($299.00) £299.00 exc vat

($358.80) £358.80 inc vat

SILICONE LUMENITION LEAD SET FOR JAPANESE AIR CON ...

BLS515

100% silcone translucent outer sheath, 8mm lead set with stainless steel wire spiral bound wire giving instant and greater resonance, Kevlar fibre core and a ferromagnetic layer for EMC suppression by Luminition. Top end of ignition lead sets.

($40.50) £40.50 exc vat

($48.60) £48.60 inc vat

HEAD STUD AND NUT KIT WITH A+ FLANGED NUTS

C-AHT279A

This kit of head studs is the best available for road and lightly tuned engines. See the C-AHT280 set for highly tuned engines.

The material spec is alloy steel heat treated to 75 tensile tons per square foot minimum and finish...

($51.92) £51.92 exc vat

($62.30) £62.30 inc vat

MINI 1275 CAM LINER SET

MS3063

You should replace the camshaft bearings every time the block goes to the machine shop. These bearings fit all late model 1275cc blocks (the ones without tappet covers on the back) It's almost too simple and thus often overlooked during a rebuild. Ca...

($15.75) £15.75 exc vat

($18.90) £18.90 inc vat

LOWER POLY STABILISER BUSH KIT

C-STR633

Stabiliser bush kit for lower engine steady

($14.40) £14.40 exc vat

($17.28) £17.28 inc vat

CRANK THRUST WASHER SET +0.30" 1275

ACL2136-030

Set of +0.030" size 1275 crank thrust washers.

($11.25) £11.25 exc vat

($13.50) £13.50 inc vat

MINI SPARES COMBINED BLOCK/GEARBOX GASKET AND SEAL...

AJM100MS

Mini Spares best quality complete gasket and seal kit for engine block and gearbox,for all common engine types and sizes.

Also comes complete with Mini Spares Evolution clutch oil seal 13H2934MS, differential oil seals...

($26.00) £26.00 exc vat

($31.20) £31.20 inc vat

SPORTS COIL FOR BALLASTED IGNITION SYSTEM 998 FROM...

MSC110

Sports coil for ballast resistor type ignition.

Best internal parts tested and another intermotor top product.

Its not the name on the outside but whats on the inside which matters.

Original type coil bracket 12G29...

($17.60) £17.60 exc vat

($21.12) £21.12 inc vat

SIMPLEX TENSIONER 6 PIECE SPECIAL KIT

MSSK051EVO

Parts required to stop timing chain rattle on A plus engine using special anti stretch single row chain 3H2127EVO.Last chance to buy with the plate and pin to hold the tensioner as they are obsolete from Rover.

Fitted to 998/110...

($35.16) £35.16 exc vat

($42.19) £42.19 inc vat

PERFORMANCE 8mm PLUG LEAD SET RED

C-27H7779RED

Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...

($13.19) £13.19 exc vat

($15.83) £15.83 inc vat

BATTERY CABLE RETAINING BRACKET 85 ON