Engine mount bolt kit for manual cars, 1 kit requried per car.

Spring seat shims (set of 4), 0.020" thick (0.5mm).

Spacer shims to increase valve seat pressure and overall spring rate.

These were also used on all the 8 port head valve seats to prtect the alloy seats from wear. (8 port now C-AHT...

Timing cover front plate and tensioner plate bolt and washer kit. Comes with all parts to fit the cover except for the counter sunk screws if fitting a duplex kit (our duplex kits all come with these).

This kit of head studs is the best available for road and lightly tuned engines. See the C-AHT280 set for highly tuned engines.

The material spec is alloy steel heat treated to 75 tensile tons per square foot minimum and finish...

Set of +0.030" size 1275 crank thrust washers.

Mini Spares best quality complete gasket and seal kit for engine block and gearbox,for all common engine types and sizes.



Also comes complete with Mini Spares Evolution clutch oil seal 13H2934MS, differential oil seals...

ACL Race Bearings



ACL Race series bearings are precision manufactured to a wall thickness of ±0.0040mm giving engine builders close control of vertical oil clearance.

What is the purpose of ACL Race series bearings?
...

Mini Spares Evolution Lightweight Performance Piston-single piston and rings.

Press fit only. Same design as C-STN103 but different manufacturer

The ultimate in lightweight die cast pistons, available in +.020, +.040 & +.060 sizes,...

24 teeth primary gear for all pre A plus 1275 engines with a floating bush fitting to suit stepped crankshaft.



Uses a floating bush with a circlip to hold it in place. This primary gear is suitable to use along with Standard pre a...

Fitting kit for 22A2204MS clutch arm with a square end. The plate to fit on the end of the arm in this kit is 20mm wide at both ends see 2A3601MS but earlier arms used 25mm down to 20mm wide see 2A3601.
<...