Follow your speedo cable to the gearbox and it screws onto an alloy housing bolted to the gearbox. This is the gasket between the housing and the gearbox.

Oil seal for speedo drive pinion cover (DAM8488)

:USED: Speedo cable drive pinion in the gearbox with 17 teeth, it was used with a 6 tooth drive spindle on all 10" wheel cars pre 1980.

Either brown or plain white sort of colour about 20.50mm to 21.12mm in diameter and very similar to [lin...

Secondhand (used unit)only. This sits under the 28G251(DAM8488) alloy housing where the speedo cable connects to on the gearbox and the speedo drive pinion slots through this.Obsolete from Rover we are offering these old used units in ca...

Gearbox output shaft housing gasket for all minis except auto.

Sold singly 2 required per gearbox.

Genuine new 6 tooth speedo drive spindle that mated with 17 tooth speed pinion 22A1881 on cars with 10" wheels before 1980 plus any year 1275GT. Also 12"wheel cars with 3.44 final drive 1984 on. On the Metro mini this was used with 17 an...

Genuine RHP Outer support bearing for the first motion shaft. Comes with bearing and outer race. You MUST REPLACE the outer race when using the new bearing. An easy way to remove the old race is to clean the housing very well, remove the circlip, and...

this is the large clip that retains the outer track of AAU8424 bearingin your clutch case for the roller bearing that sits on the end of the 1st motion shaft. The little circlip that holds the bearing on the shaft is CCN110

Used ,but thread checked with speedo cable and cleaned-if you have ruined the thread or lost this alloy housing, this is a cheap replacement.

You need to purchase a new seal, see AAU2304.

The gasket for this is [link]GU...