£600.00 exc vat
£720.00 inc vat
Limited stock
Pictu...
£600.00 exc vat
£720.00 inc vat
Limited stockRecommended usage 1 x GS116394 to fit one mini.
Spanner for adjusting the jet on silver coloured original jets on HS type carbs
short handle to enable use in tight places such as a mini engine bay.
WILL NOT FIT LATEST BRASS TYPE ADJUSTER NUTS AS FITTED TO REPLACEMENT CARBS SINCE ...
Every mini owner will require this 1.5" socket at some stage as it does the pre A plus flywheel bolt when changing the clutch and also the swivel pin retaining nuts on your hubs plus the mainshaft/pinion nut in the gearbox. 1/2" Drive.
...
this is called agrinding stick because it is used for sticking on the cylinder head inlet and exhaust valve heads to lap them in with grinding paste on heads without lead free inserts--valves usually do not need grinding in when new and fitted to new...
Mini Spares best quality complete gasket and seal kit for engine block and gearbox,for all common engine types and sizes.
Also comes complete with Mini Spares Evolution clutch oil seal 13H2934MS, differential oil seals...
Mini Spares genuine part, made for reliability, because the current Rover 22G2033version is not good enough. These specials are CNC grooved for correct shape and machined for concentricity using the original type fixings to get the corr...
Key barrel set for Mk3 onwards door handles and boot handles.
Clip for Door Handle required when changing barrel set. Heavy duty round spire clip specially made for the job.
Used on all MK1/2/3 bootlids there are 26 little holes drilled around the inner edge to hold the seal on and this kit contains the 26 clips. For single clips see 14A6585. Later cars 1988 on fitted a seal to the body only. (CKE10018)
The bronze washer for the planet gears in the differential for pre A plus gearbxes. You can use the DAM5071 and cut the lips off.
Brighten up your car with these chromed plinths for the wiper wheel box on MK3 Minis on to the very last models. Includes 8 sided nut for all MK3 cars 1970 on.
For MK1/2 see 37H6042C.
Minispares were the first company to produce these layshafts for performance engine/gearboxes as the standard type would flex and result in the breakage of the bearings causing seizure. Produced in an upgraded material and heat treated to the correct...
Lower differential housing paper gasket for old magic wand and remote type gearboxes, rod change gearboxes.
The bronze bush in the differential housing that the gear change selector rod sits through which should be lightly greased.
Mk III Chrome boot handle as fitted to all saloons from 1970 on. Includes 2 keys and paper gaskets.
If you want your door and bootlid to have new or matching keys this is the easy way. The standard set includes two barrels with matching keys. This is only suitable when you require a drivers door and boot handle to match on MK1/2 cars only. This fit...
Gearbox oil strainer to gearbox internal case gasket and also used on the C-AHT54 special oil pick up pipe. One also sits on the outer plate held onto the gearbox outer casing by 2 screws.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.