A Non genuine item but this is the only option available and fairly good quality. A rear valance with the long side pieces makes this panel unique to the Riley Elf and wolseley Hornet only. Floor sections are not available and this rear valance is on...
Really a built up half front end for the mini clubman, consists of a lower panel with headlamp panels,slam panel and stiffener between the front and slam panel. 76 ON--no inner or outer wings
This Non genuine pattern panel has the holes for windscreen wipers and jets with barely an inch of pillar.
On cars from 1992/3 on check the original windscreen drain channel as the VIN numbers were stamped above the clutch master cylinder-wi...
A post inner closing panel/siffener plate R/H external hinge cars.
Not always stocked owing to lack of demand but available to order.
A post inner closing panel/siffener plate R/H-external hinge cars
Not always stocked owing to lack of demand but available to order
Small angled bracket fitted by factory to stiffen front wings to A panels
Bracket from the centre of the transmission tunnel up to the centre of the back seat pan
Late type centre tunnel just over 12" wide to first floor indentation with brackets-also shown is the electric cable protector strip 24A1463.
ADA36002EC is same but is less a strengthening bracket for pre tensioned seat belts as fitted from ...
Floor pan section with late type outer sill with inner sill all fixed to the floor pan which goes to the edge of the centre tunnel . The jacking point and strengthening bracket are all part of this useful L/H repair section
Floor pan section with late type outer sill with inner sill all fixed to the floor pan which goes to the edge of the centre tunnel . The jacking point and strengthening bracket are all part of this useful R/H repair section
HMP441017 - panel that can be either welded or bolted into place on the bulkhead to replicate the original rotodip piercing.
Very handy for historic appendix k spec cars or owners with Weber air boxes worried about cur...
R/H Inner hinge type A post repair panel with hinge fitting holes mini, MK3
this is a genuine heritage part.
L/H Inner hinge type A post repair panel with hinge fitting holes mini, MK3
this is a genuine heritage part.
Upgraded R/H "A" panel for all Minis with internal hinges,1970 on.
A single wall panel has has a tendency to develop rust spots and is probably one of the most common panels replaced on the Mini.
Only available from Mini Spares th...
Upgraded L/H "A" panel for all Minis with internal hinges,1970 on.
A single wall panel has has a tendency to develop rust spots and is probably one of the most common panels replaced on the Mini.
Only available from Mini Spares th...
Slat type front grille section for mini van which will need trimming before welding into recess of either an original damaged front panel or a saloon version.
It is sold as a grille size panel and can be fitted as such when painted with [li...
O/S/F wing t for 1996 on cars. THIS WING STILL NEEDS MODIFYING to allow for fitting of Sportspac arches and 13" wheels. After trimming/cutting to size remember to replace or renew the stiffener lip ALR360380
Has the headlamp re...
Non genuine but a correct replica part for all pre 1964 cars with a full skirt lower front valance panel without cooling cut outs on the corners which was introdeced in 1964 to help drum brakes cool and be more efficient
Small lower repair section of the rear quarter panel, if you need the door step section also see part number MS28L.
For Mk3 but can be used as a part of repair sectiion for Mk1/2
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.