part inner wing R/H from Damper bracket mounting points forward MK2/3 except Clubman. 1969-91 not Mk1/2 as it has air hole in side
NON genuine panel
Part inner wing L/H from Damper bracket mounting points forward. MK1/2/3 except Clubman. This panel has radiator cooling slats as fitted to 1991
NON genuine panel only as part panel
Front of door frame repair panel down to door step L/H non genuine
Curley Mouldings fibreglass front end, as used on Mini7 and Miglia race cars. Will need trimming for a perfect fit.
Curley Mouldings carbon fibre front end, as used on Mini7 and Miglia race cars. Will need trimming for a perfect fit. Bonnet not included.
The rear lower side and rear corner panel for the Mini Van, Pick-up and Estate are all the same. This repair panel is intended to be spliced in to replace a most often rusted spot!
Front of door frame repair panel down to door step R/H non genuine
For vehicles with external hinges and sliding type windows this is a full inner front wing with the wheel arch panel. The panel is what that the outer A panels for the hinges attach to. This is the right hand panel made by Heritage but not 100% perfe...
For vehicles with external hinges and sliding type windows this is a full inner front wing with the wheel arch panel. The panel is what that the outer A panels for the hinges attach to.This is the left hand pane wing with radiator vent slats but not ...
Lower Clubman grille grommet between legs and body to stop grille rattling, 3 required per car, injection moulded.
This is the crossmember for the dash at the back of the engine bay which holds the master cylinders. When fitting to Clubmans extra end pieces are required. Fits 1976 on but does not have PDWA valve bracket. The original Rover parts are supplied with...
Really a built up half front end for the mini clubman, consists of a lower panel with headlamp panels,slam panel and stiffener between the front and slam panel,
but not inner or outer wings
This inner wing has no radiator cooling fin slots or the round hole for electric fans and therefore is only suitable for cars with the front mounted radiator such as Twin points or specials.
Complete rear back panel section from roof to bumper valance with MK1 lamp and bootlid apertures but the backlight(rear window screen) aperture is only for models from 1967 to 2000. This panel is Not available genuine with the original MK1 size rear ...
The whole front bulk head assembly with bonnet hinges on the lower dash panel, crossmember and toe board with start of rod change floor tunnel,reinforcements for holding steering rack and heater mounting points --made for vehicles from 1990 on with 1...
Reproduction version os ASJ360070. For the twin point only as it changed shape to accommodate the front mounted radiator and different bonnet fittings.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.