Mk3 loom for 72-75 saloons with alternator, 2 piece (front and rear).
PVC loom for Portuguese built Mini Moke, comes complete front and rear.
Rear wiring loom for SPI cars. These have bullet connectors to join the front loom, later cars had a multiplug which use YMD10717.
Rear loom for 1992 on carburettor cars with a 13 way Econoseal plug.
Plug and fly loom for later 2/3 clock speedos, useful if you are converting from a centre speedo to later clocks or just repairing a standard loom.
3 piece braided/cloth wiring loom to suit 1964-1967 van, pickup and traveller models with ignition start switch.
Front and rear loom for 60-62 Mini pick up, braided with floor start.
Braided Wiring loom for MK1, floor starter with coil on dynamo and temp gauge. 1962-63 approx. 3 clock type
Engine harness for SPI 1997 onwards Japanese spec cars with manual transmission.
(MPI engine block, SPI injection system, Air con, GCL204 type ignition coil)
Please note where original plugs are no longer available the wires are lef...
Engine harness for SPI 1997 onwards Japanese spec cars with automatic transmission.
(MPI engine block, SPI injection system, Air con, GCL204 type ignition coil)
Please note where original plugs are no longer available the wires are...
Main and dash wiring loom except ECU engine harness for SPI Cooper with no dim dip to SN58746, no alarm --no longer available from Rover.
Mini Mk 4 998 oval centre dash,twin column stalks,rocker switches including rear fog and heated rear window,reverse lights and rear fog lamp is on headlamp circuit. Intertia starter. To go with AN145 rear loom.
mainly for 1980-1...
Dip switch lead for right hand drives cars, these are not included with new looms.
Dip switch lead for left hand drive cars, these are not included with new looms.
Wiring loom, front ant rear for van and estate 1960 to 1962 floor start. Like 3222 loom but with alternator conversion.
MK2 Mini Moke Wiring Harness Set - with Dip Switch on Steering Column. Dynamo
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
Clip to retain the speedo cable to the bulkhead on pre 82 cars approx. This clip is also used to hold the loom to the inner wing on some cars.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.