Rear wiring loom for SPI cars.

Rear body harness with speaker wires, known as thick wall type which was replaced by thin wall PVC covered wire type in 1989. AN169 is the thin wall equivalent and occassionly fitted or found on early cars wothout any problems.

...

Plastic holder for the later flasher unit GFU2218. Needs to be mounted to the bulkhead prior to fitting the flasher unit to the holder

Double bullet connector used to join the front loom to the rear loom enar the wiper motor.

The wiper motor drives a rack inside the metal tube that fits beneath the dash of the Mini. The rack is very well protected inside the case, but the problem is that the tube is often bent and/or rusted. Our special kit supplies all 3 pieces and the s...

Range of distributors with modern day curves built,programmed and tested for Mini Spares in UK.

Beware of cheap China made units that are poorly made- see note at bottom. GEU930 25D 850/early 998

12G2140 ...

This is the latest model fuse box as used on all Minis after 1976 and all MG Midget/Sprites with 1275cc. Simple and easy to replace or upgrade from the earlier version. This box has the added advantage of having 4 fuses in place of the earlier vers...

circuit breaker for safety as required in motorsport

The switch has to be accessible from inside and outside the car.The external trigger should be located on the windscren scuttle panel -preferably the drivers side . It should be clearly ma...

This was the first mini distributor cap to have screws hold the cap to the body from about 1990 on, when electonic ignition was introduced. Therefore there is no points or condenser but the rotor arm to use is GRA2143. Fits all 1992 onwa...

Glass type 15 amp fuse.