Rod with chamfered ends about 57.2mm long(shorten to 54mm for twin HS4) which has AUE586 and AUE587 clamps on to fit between SU twin carbs for the linkage. Quantity of One is usually required per set up plus a 12A31...

This fitting kit suits all later day 1.25" and 1.5" twin carb set ups where the balance rods between the carbs required are equal length (2.25"), some early carbs had the balance bar with a triangular plate that were a shorter length. The kit has the...

Spacer with gaskets fitted for any 4 bolt fitting carb such as HS6 HIF range about 9/16" (14.5mm). As this is the only thick spacer you need to check stud length.

Accelerator bracket for twin carb models, mounts to inlet manifold.

The metal washer that goes up against the seal on the jet where it enters the float bowl on all HS type carbs

These Swedish made Misab plates are known as the best for mounting your 40/45DCOE carb to its manifold to avoid fuelling problems. Sold singly per gasket

Intake manifold gasket for Arden 8 port head.


4 required.

Stainless steel twin HS2 heatshields kit. Comes with link bar, bolts, nuts and springs.

This throttle return spring fitted every HS2/4 single SU carb and also on the twins as fitted by the factory. Twin carbs used AEC2075 for choke return. Total length 90mm.

Manifold to carb gasket for HS2 single and twin carbs, usually 3 per carb required.