The newest development in the A-series engine is the use of these nuts with swedged-on washers. The washer will not separate from the nut, so you won't lose it. Yet the nut rotates independently while you tighten it. What a great idea.
Countersunk, crosshead screw. 1/4"unf 19mm (3/4") total length.
This screw fits the internal door hinges on wind up window cars and the striker plate on the B post.
Wingnut to secure air box to carb / carb elbow.
Suitable for single HS4 , HIF38 type plastic air box.
Not for Cooper S twin carb type metal air box. Cooper S type use 12G2705, a shorter version.
On all cars with a steering lock there are safety shear bolts on the column which will need replacing if removed. These are the bolts that hold the steering lock halves together.19mm (3/4") long. 2 required par car, but sold individually.
Original Bolt with a special length shank for the front suspension tie bar to the lower arm. Always check this out for any signs of wear and replace accordingly.
Only wrong length parts were available in the market so these are the correct l...
Screw for either end of the material check strap on MK1/2/van/pickup minis with external hinges. The head of this screw is chromed for a superior finish.
The clips that hold the seat squab vinyl to the frame on front seats and the headlining. These clips are available seperately as GHF1500.
Rear hub nuts on the mini are sided as the threads are different. This is for the LEFT hand rear. This has a left handed thread.
See NL611041 for the right hand nut.
This is the correct thick flat washer for a suspension tie bar rod. The washer has a 7/16" hole is 1.5" wide. See 2A4328 for the correct dished washer.
Countersunk crosshead screw. 1/4"unf / 16mm(3/8") total length.
To hold the drive flange to the brake disc on the Cooper S type 7.5" wide brake set up. Also holds striker plate for door.
COUNTERSUNK, CROSSHEAD SCREW.31mm 1.25" TOTAL LENGTH 1/4 UNF.
Screw to hold the lock assembly on the door of MK3 cars with internal hinges and wind up windows. On new doors or for easy fitment use special screw ZCT410 with cutti...
Special plastic covered clevis pin(first one to appear on a mini) is for the later brake system with servo and intoduced on single point injection.
assorted plain steel UNF nuts with approx qty - 100-3/16" 80-1/4" 70-5/16" 40-3/8"
assorted flat washers with approx qty- 200-3/16" 200-1/4" 200-5/16" 100-3/8" 50-7/16" 50-1/2"
Screw to hold 14A6832 MK1/2 Striker plate.
Special 3/16" screw with a pointed end which helps locating when fitting, this has only 1/4" thread, a very short screw with countersunk head.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.