($36.59) £36.59 exc vat
($43.91) £43.91 inc vat
In stock
see ALE2928 for air vent type.
($36.59) £36.59 exc vat
($43.91) £43.91 inc vat
In stockRecommended usage 1 x ALE2927 to fit one mini.
The black vinyl covering that lays on your lower dash shelf. For cars after 1970 where the facia panel is not a full metal panel you must fit (link)DT3076(/link)
Dash liner black painted cardboard without airvents and oval hole for deluxe speedo cluster.Not for single speedo only cluster.For Vinyl leathercloth type see ALE2927
The black vinyl covering that lays on your lower dash shelf. For cars after 1970 where the facia panel is not a full metal panel you must fit (link)DT3076(/link)
Fitted for safety regulations to all MK2 minis from 1967-80 except Sweden and Canada to 1975 (not any MKI or van and pick up). Later commercial type minis did have it fitted with 3 clock speedo pod. This is a hard foam pad at the lower edge of the pa...
Dash liner black painted cardboard without airvents and oval hole for deluxe speedo cluster.Not for single speedo only cluster.For Vinyl leathercloth type see ALE2927
Black painted liners for deluxe cars with air vents and central speedo and 2 gauges.
Dash liners with air vents for on de luxe versions with centre speedo and two gauges which are black vinyl covered as opposed to the painted type. Not for the single centre clock only. The cardboard is cut out but the vinyl needs trimming when fittin...
Brackets and fittings to mount the MK1 speedo housing.
The classic Mini phone holder with USB replaces the existing ashtray in the padded dash rail.
Key Features:
Plate is made from powder coated 3mm steel
Spring loaded clamp, hold phones between 59mm to 106...
Black vinyl dash liners suitable for 2 and 3 clock clubman type dash with the offset clocks (Left hand Drive).Vinyl will need cutting out for vent holes but the cardboard backing is pre cut.
Printed circuit board for 1989 to 1996 3 clock Nippon Seiko type Mini gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.
door cappings in carbon fibre to compliment carbon fibre finished dash
Printed circuit board for pre 1989 cars with Smith's type 3 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.
Works Dash for LHD cars.
The later type more common dashes as used on the classic works Monte Minis and rally cars from ST Abingdon.
In crackle black finish.
Attaches to top and bottom parcel shelf rails either side...
2 outer rings and 2 inner knobs which have to be stuck on.
Chromed version of the standard demist vent on early cars where the ashtray is
mounted in the top and middle of the metal facia. Not for later cars with large
padded windscreen rails and ashtray in the front such as Mini Clubman and...
The black plastic pod which mounts the speedo and two gauges in the original central position. In the 1970's and 1980's a great number of Mini owners caught the customizing bug and a lot of Minis had custom dashboards installed. Now we're going the o...
ALSO SUITABLE FOR EARLY MK3 CARS THAT RETAINED THE DASH MOUNTED STARTER SWITCH AND TOGGLE SWITCHES CARRIED OVER FROM THE MK2 CARS.THE CHROME TRIM FOR THIS IS ALA6640
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.