($16.40) £16.40 exc vat
($19.68) £19.68 inc vat
In stock
($16.40) £16.40 exc vat
($19.68) £19.68 inc vat
In stockRecommended usage 1 x VGA4192 to fit one mini.
Black vinyl dash liners suitable for 2 and 3 clock clubman type dash with the offset clocks (Right Hand Drive).Vinyl will need cutting out for vent holes but the cardboard backing is pre cut
The black vinyl covering that lays on your lower dash shelf. For cars after 1970 where the facia panel is not a full metal panel you must fit (link)DT3076(/link)
Fitted for safety regulations to all MK2 minis from 1967-80 except Sweden and Canada to 1975 (not any MKI or van and pick up). Later commercial type minis did have it fitted with 3 clock speedo pod. This is a hard foam pad at the lower edge of the pa...
Dash liners without air vents for either side of the speedo on deluxe versions such as the Cooper S with centre speedo and two gauges which are black vinyl covered as opposed to the painted type. Not for the single centre clock only.
see [li...
Black painted liners for deluxe cars with air vents and central speedo and 2 gauges.
Dash liners with air vents for on de luxe versions with centre speedo and two gauges which are black vinyl covered as opposed to the painted type. Not for the single centre clock only. The cardboard is cut out but the vinyl needs trimming when fittin...
Black vinyl dash liners suitable for 2 and 3 clock clubman type dash with the offset clocks (Left hand Drive).Vinyl will need cutting out for vent holes but the cardboard backing is pre cut.
Printed circuit board for pre 1989 cars with Smith's 2 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.
Works Dash for LHD cars.
The later type more common dashes as used on the classic works Monte Minis and rally cars from ST Abingdon.
In crackle black finish.
Attaches to top and bottom parcel shelf rails either side...
2 outer rings and 2 inner knobs which have to be stuck on.
Chromed version of the standard demist vent on early cars where the ashtray is
mounted in the top and middle of the metal facia. Not for later cars with large
padded windscreen rails and ashtray in the front such as Mini Clubman and...
The black plastic pod which mounts the speedo and two gauges in the original central position. In the 1970's and 1980's a great number of Mini owners caught the customizing bug and a lot of Minis had custom dashboards installed. Now we're going the o...
ALSO SUITABLE FOR EARLY MK3 CARS THAT RETAINED THE DASH MOUNTED STARTER SWITCH AND TOGGLE SWITCHES CARRIED OVER FROM THE MK2 CARS.THE CHROME TRIM FOR THIS IS ALA6640
Small details can make a big difference to a restoration. New covers for the defroster vents won't make your car run better, they probably won't even make the defroster work any better, but they sure look better. These come in flat black primer, read...
Ashtray that sits in the upper padded dash on all vehicles with 2/3 clocks positioned in front of driver. Early cars had flat plastic tray face whereas later cars had crinkly type face which is the only type available- They all fit the same.
Late type swith carrier with 4 square holes plus heater and choke cable holes-uses the ratchet type choke cable with D shape fitting--earlier cars used round hole for pull and push chooke cableCZH3591
Black dashboard for cars with 3 clock speedo cluster in front of the driver on left hand drive cars.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.