SPI REPLACEMENT FUEL PUMP ONLY FOR WFX10045
WFX100811

($67.20) £67.20 exc vat

($80.64) £80.64 inc vat

In stockIn stock
The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank before fitting and drive your mini more to avoid water build up.

Replacement pump only for the WFX100810 (doesn't come with tank fittings)

Requires a small amount of wiring modification to fit, but half the cost of the

original unit. Small terminal is EARTH/ground.

($67.20) £67.20 exc vat

($80.64) £80.64 inc vat

In stockIn stock

Recommended usage 1 x WFX100811 to fit one mini.
Fuel Tanks and Pumps - Qty 1

Recommended products

Gasket/seal for mounting the fuel pump to tank for SPI and MPI Mini's

Alternative products

Fuel pump with filter for injection models where the pump is located inside the tank. This pump was originally for the twin point but is now used on both Single or Twin point injection models as the ECU adjusts the pressure on demand.

See [l...

People also bought products

The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank out before fitting and drive your mini more to avoid water build up.

Replacement pump only for the original WFX100810<...

Mini Spares Non Genuine version mechanical fuel pump. Brilliant aftermarket alternative for cars pre 1990.

Drives off the camshaft at the rear of the motor. These pumps are generally reliable but when a diaphragm goes bad it can be very bad ...

Non Genuine metal bodied electric fuel pump with metal banjo pipe ends for long life,with blue plastic end. Ethanol tolerant and resistant internals.

This is a cheaper alternatives for the original SU pumps, different to look at and fit but ...

THE ELECTRICAL CIRCUIT FOR THE FUEL PUMP INCORPERATES AN INERTIA FUEL SHUT OFF(ifs) SWITH WHICH WILL STOP FUEL BEING DELIVERED TO THE ENGINE IN THE EVENT OF SUDDEN DECELERATION--It is fitted in the engine compartment, fixed to the bonnet switch brack...

Gasket/seal for mounting the fuel pump to tank for SPI and MPI Mini's

Fuel pipe from the fuel filter to engine on spi and mpi models up to chassis no WD169574 when fuel filter GFE7059is fitted.



Tube nut has four threads, the metal pipe has a union on the end that is fatter than the metal...

The 1990-1 models of the Mini with 1275cc engines and HIF44 carbs use this different mechanical fuel pump. Driven off the camshaft at the rear of the motor these pumps are generally reliable but when a diaphragm goes bad it can be very serious as oft...

Points for the original style AUF214 SU electric fuel pump,if the car has not been used for a while these points often stick so you need to give the pump a few careful whacks to help them disengage. If they stick again check them over f...

Made for the facet solid state range of pumps (SS501/SS502/SS503) this pre filter with screw in union must be used to eliminate fuel tank debris damaging either the filter or carb/engine etc.

Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.

Orange ...

Special rubber hose 1/4" bore for use on petrol lines, this is in black and not armour plated outside but does have internal reinforcing. Supplied as pre cut 1m length with 2 clips and is safe to use with modern fuels with higher ethanol content. SAE...

Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.

Orang...

Original body but with latest solid state electric functions for reliability

see AUF214EP for positive earth type.

Used on Facet range of solid state and silver fuel pumps SS501/2/3 with 1/8" nptf thread size with 1/4" standard fuel line.

Only used for STC505 Facet pump range or solid state SS502 & SS503 and silver fuel pumps with 1/8" nptf thread size with 5/16" upgraded fuel line.

The round gasket that sits under the AUB663 plastic outlet banjos on every electric SU pump, also fits under the filter.

Before the days of Aeroquip, the British were making their own braided steel fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. British Length 7.5"...

Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.

Orange ...

If you have a mechanical fuel pump fitted to your engine this spacer block fits between it and the engine. The gaskets are available seperately however as GUG705779GM.