Cup type core plug for all cooper S only @ 41.4mm wide.

4 required per engine.

Brass type core plug for engine. Originally, engines had brass oilway plugs (2K1345) 1/4" hole fitted. These cup type plugs replaced them about 1985. 12.7mm cup type plug about 9.6mm deep. Fits 1/2" hole.

All good engine tuners ...

Lightweight billet aluminium distributor hole blanking plug for pre A+ engines

Genuine Mini Spares engine front plate for pre A+ plus timing gear.



this fits engines using the early egg shaped cover



This plate has been modified by counter sinking the 2 main cap bolt holes to accept countersu...

Replace with new camshaft,it's almost too easy to overlook during a rebuild. Camshaft bearings are pressed into the block and thus are usually done by a machine shop. You would not rebuild an engine without replacing the rod bearings, so why not the ...

Steel ring set, 3 compression ring @ 0.0625" oil ring 0.125 as per original 998 pre A plus and 1098cc versions inc morris minor and sprite range.

Timing cover front plate and tensioner plate bolt and washer kit. Comes with all parts to fit the cover except for the counter sunk screws if fitting a duplex kit (our duplex kits all come with these).

These Swiftune die cast performance pistons are part of their new Heritage range and are manufactured by global leading F1 German piston manufacturer Mahle. These pistons have been developed using their 50 plus years of experience. Glyn Swift was usi...

These Swiftune die cast performance pistons are part of their new Heritage range and are manufactured by global leading F1 German piston manufacturer Mahle. These pistons have been developed using their 50 plus years of experience. Glyn Swift was usi...

You should replace the camshaft bearings every time the block goes to the machine shop. These bearings fit all late model 1275cc blocks (the ones without tappet covers on the back) It's almost too simple and thus often overlooked during a rebuild. Ca...