(33,30 €) £33.30 exc vat
(39,96 €) £39.96 inc vat
In stock
(33,30 €) £33.30 exc vat
(39,96 €) £39.96 inc vat
In stockRecommended usage 1 x MSSK065 to fit one mini.
2 of these rubber mountings are fitted at the front of the front subframe on all vehicles from 1976 (mk4) on. To help stabilise steering by stopping subframe movement. We do many equivalents so see our accessory catalogue, also see 21A2624
Priced each, 2 of these are fitted to the rear of the front subframe on all cars from 1976 on. These original rubber type can be replaced by alloy or other equivalents, see our accessory catalogue. Also see 21A2599 for genuine.
Fitted to rubber mounted subframes from 1976 on this packing piece goes between the front panel and the subframe mounting points. You might be surprised how many of these were fitted to your car when it came out the factory. When replacing the front ...
Towing eye that fits in place of the bolt holding the front panel to the subframe. For stronger later version see KPU100160.
When using certain accessory tow bars make sure the towing eye is in the right position to suit or it w...
This is a budget way of improving the stability of the front subframe leaving the rear mountings standard for quietness.
It only includes the 4 poly tower spacers and for the front of the front subframe 2 poly spacers and 2 metal washers.
Original Bolt with a special length shank for the front suspension tie bar to the lower arm. Always check this out for any signs of wear and replace accordingly.
Only wrong length parts were available in the market so these are the correct l...
This is the correct thick flat washer for a suspension tie bar rod. The washer has a 7/16" hole is 1.5" wide. See 2A4328 for the correct dished washer.
The correct screw for holding the 2A4267MS bump stop for the upper arm on the front suspension. 3/16"unf 1/2"long flat head phillips type screw.
Large cup retaining washer for the front suspension tie rod.
Sold singly 1 required per rod and 2 per car
Fixes fan blade to water pump and corner bars to overider on deluxe bumpers. Also used for locating plate AHU2379.
Fits top and bottom of the front damper and the lower rear damper to keep the bush from moving in the damper (shock absorber) eye sockets. 3/8"hole.
1.4mm thick by 24.6mm wide.
Engine mount bolt kit for manual cars, 1 kit requried per car.
This special shake proof washer should be replaced. Found on front hose.
Also used on 21A1524 hydrolastic pipe adaptor.
Fixes fan blade to water pump and corner bars to overider on deluxe bumpers. Also used for locating plate AHU2379.
Large cup retaining washer for the front suspension tie rod.
Sold singly 1 required per rod and 2 per car
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.