Nut for swivel pin.

For 1275cc engines with sandwich plate fitted except when PEQ10019 large bore thermostat housing is fitted.(fitted to HIF carb models between 1990-91). It has been used for these models however by extensive modifying around the horseshoe...

For 850, 998, 1100 cylinder heads where there is no sandwich plate under the thermostat housing.

Fits from the thermostat housing and end manifold stud. The other end bolts to the bulkhead where the heater hoses go through the body.

Every nut, washer, bolt, rubber bush and 2 pins that hold the rubber bushes that are prone to rusting badly and are required every time you do a subframe change. Including the 2 large penny washers this kit has 36 components. Other companies offer l...

Performance geometry kit includes tie bars, lower arms plus performance bushes for lower arms and tie rods. This is basicaly the same kit as MSSK3013 but less the rear tracking and camber brackets.

parts in kit to transform hand...

This kit contains all the parts from MS44 plus the 4 cast trunnions that hold the rubber bushes. This complete rear subframe fitting kit is what the factory fitted to minis up to 1976 on but the later kit MS41 will fit early...

All the Nuts, bolts and washers you will need to fit a rear subframe to your car, less the support pins and bushes. These kits are aimed at those wanting to fit different rear subframe bushes such as the Poly bushes.

Boot hinge gaskets and fittings for original type hinges

Engine mount bolt kit for manual cars, 1 kit requried per car.

5/16" UNF cage nut as fitted to CZH3241 tank bracket on cars fitted with a 7.5 Gallon fuel tank. Uses 13H7583 bolt

5/16" UNF A2 Stainless Steel Plain nut, ideal for engine bay dress ups or nuts that you don't want going rusty!

M6 metric lock nut -fits 14A6779ms bumper

Metric M6 PLAIN NUT.sold singly per item

Required for non genuine stainless steel and chrome bumpers.

Fits radiators with metric fittings such as ARP1110

Metric flanged metric M6 nut as used on engine, air con units and heaters from 1990 on.

Plain half thickness half inch nut as used on our C-AJJ3365 arms and steering rack adjustment nut for track rod ends.

New set of metric studs, bolts, nuts and washers as supplied with the alloy external hinge kit (PEASE NOTE: This kit is NOT suitable for the original hinges). The studs have allen key socket ends to help put them into the hinge easily without damage,...

Multi purpose square plastic plug/nut for No8 screw size was used on many door fixings and fuse box to body.



Also suitable for Twin Point indicator fixings.