£5.65 exc vat
£6.78 inc vat
In stock
Approx 23.75" long with internal 5/16" end and 1/2" other end.
GHC406 jubilee clip for large end and ACH5854 petrol pipe clip for small end.
£5.65 exc vat
£6.78 inc vat
In stockRecommended usage 1 x 12A1735 to fit one mini.
To convert a standard UK spec Single Point Injection car to HIF44 carb. This kit includes wiring looms,fuel tank,fuel pump, carb, air filter and inlet manifold.
universal crank case breather with red top, with a 13mm(1/2")neck size.
2"wide top (50mm) and 35mm high
Chrome top crankcase vent filter with metal 1/2" inlet flange, 47mm filter diameter x 1.5" high(40mm). Another cleanable filter from K&N.
universal crank case breather with blue top, with a 13mm(1/2")neck size
2"wide top (50mm) and 35mm high.
Universal crank case breather with chrome top and a 13mm(1/2")neck size.
2"wide top (50mm) and 35mm high
Original equipment quality for factory built engines giving longer life expectancy on road cars under variable conditions of oil and use. These are the 1275cc mains as fitted to A Plus engines with the locating tab in the middle rather than to the ou...
AC Dodd Road Sport Plus camshaft, ultimate road cam, lumpy idle but still driveable. Please see picture for full cam specs.
ACD - RS+
Power Band (Rpm): 1750 - 6500
Duration @ 0.016": 268° 268°
D...
Replace with new camshaft,it's almost too easy to overlook during a rebuild. Camshaft bearings are pressed into the block and thus are usually done by a machine shop. You would not rebuild an engine without replacing the rod bearings, so why not the ...
Steel ring set,for 4 ring pistons. 3 compression rings @ 0.0625" oil rings 0.125 as per original 998 pre A plus and 1098cc versions inc morris minor and sprite range.
Timing cover front plate and tensioner plate bolt and washer kit. Comes with all parts to fit the cover except for the counter sunk screws if fitting a duplex kit (our duplex kits all come with these).
11/16" dowty seal for post 1991 cars where the original pipe has been replaced with a braided pipe or an oil cooler has been fitted using part number MOC4. used on the TCZ102
This is the large seal for the early type oil filter assembly pre spin on type.
These Swiftune die cast performance pistons are part of their new Heritage range and are manufactured by global leading F1 German piston manufacturer Mahle. These pistons have been developed using their 50 plus years of experience. Glyn Swift was usi...
These Swiftune die cast performance pistons are part of their new Heritage range and are manufactured by global leading German F1 piston manufacturer Mahle. These pistons have been developed using their 50 plus years of experience.
Glyn Swif...
These Swiftune die cast performance pistons are part of their new Heritage range and are manufactured by global leading F1 German piston manufacturer Mahle. These pistons have been developed using their 50 plus years of experience. Glyn Swift was usi...
You should replace the camshaft bearings every time the block goes to the machine shop. These bearings fit all late model 1275cc blocks (the ones without tappet covers on the back) It's almost too simple and thus often overlooked during a rebuild. Ca...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.