£2.95 exc vat
£3.54 inc vat
£2.95 exc vat
£3.54 inc vat
Recommended usage 1 x 12H4344 to fit one mini.
This is the original type of needle valve that governs the plastic fuel float in your SU carb.
An alternative better upgraded version is available as CA90.
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orange ...
Clip on the heater valve for heater cables on vehicles from 1990 where the in line remote heater valve was used. It has also been used as a clip for HIF carbs to hold the cable but the one from Rover is 13H3472.
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orang...
Throttle return springs for all twin carb variants. Usually 3 fitted.
Manifold to carb gasket for HS2 single and twin carbs, usually 3 per carb required.
This throttle return spring fitted every HS2/4 single SU carb and also on the twins as fitted by the factory. Twin carbs used AEC2075 for choke return. Total length 90mm.
Mini Spares own performance upgrsded paper gasket that sits either side of the carb to manifold spacer on HIF38/44 type 1.75" carbs.Sold singly, order quantity as required to suit your car.
Gasket for an HS4-carb and manifold .Sold seperately and order as required for your car(usually 3).
These Swedish made Misab plates are known as the best for mounting your 40/45DCOE carb to its manifold to avoid fuelling problems. Sold singly per gasket
The metal washer that goes up against the seal on the jet where it enters the float bowl on all HS type carbs
The proper slot head screw for the SU dashpot and float lid 3/16 whitworth thread.
Accelerator bracket for twin carb models, mounts to inlet manifold.
Spacer block between carb and manifold for single HS2 carb. To use on twin carbs the fixing holes need drilling out to size. 7.5mm thick