(¥1) £0.90 exc vat
(¥1) £1.08 inc vat
In stock
(¥1) £0.90 exc vat
(¥1) £1.08 inc vat
In stockRecommended usage 1 x TERM-P to fit one mini.
universal battery clamp replacement with securing bolts and marked N
Battery bar and fitting kit for all post 1990 cars whcih had the longer battery bolts.
Battery bar and fitting kit for all pre 1990 cars whcih had the shorter battery bolts.
Stainless steel small battery cable retaining bracket bolted at the front of the engine for pre engaged manual cars approx 1985 onwards.
Small battery cable retaining bracket bolted at the front of the engine for pre engaged manual cars approx 1985 onwards.
Single bullet connector used to join the front loom to the rear loom near the wiper motor.
Double bullet connector used to join the front loom to the rear loom enar the wiper motor.
Repair loom and plug for all post 1976 headlamp switches.See PM08 for headlamp switch with plug and correct wires colours for loom repair
Printed circuit board for pre 1989 cars with Smith's type 3 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.
Quality HT lead set for twin point injection minis. For use with M4 type coil. Spiral bound wire giving instant greater resonance.
universal battery clamp replacement with securing bolts and marked N
Cable for solenoid to inertia starter on Pre-1985 minis or can be used as a long earth cable.
Your battery box 5L877 should be held in place by this rubber strap.
100% silicon insulation, silicon coated suppressed conductor,braided glass reinforcement,increased working temperature 0f minus 50C to +300 degrees with improved resistance to damp and water, great fitting and spiral bound wire giving instant and gre...
This "Pigtail" wire is all that carries current through the distributor to the points.Fits 23 and 25d type distributors
100% silcone translucent outer sheath, 8mm lead set with stainless steel wire spiral bound wire giving instant and greater resonance, Kevlar fibre core and a ferromagnetic layer for EMC suppression by Luminition. Top end of ignition lead sets.
Universal post type battery earth strap with clamp type fitting and correct length for most alternatives of batteries fitted.
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
The only battery cable to run the full length of the Mini, this has a positive type terminal that clamps arond the post rather than the helmet or cap type on much earlier cars. Some cars had slightly shorter cables than this but measure your old cabl...
Genuine Rover/Unipart 4 high quality silicone plug leads for twin point injection minis. For use with M4 type coil.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.