The clip that holds the choke cable on cars from 1987 to 1991
This fitting kit suits all later day 1.25" and 1.5" twin carb set ups where the balance rods between the carbs required are equal length (2.25"), some early carbs had the balance bar with a triangular plate that were a shorter length. The kit has the...
Spacer block between carb and manifold for single HS2 carb. To use on twin carbs the fixing holes need drilling out to size. 7.5mm thick
Spacer with gaskets fitted for any 4 bolt fitting carb such as HS6 HIF range about 9/16" (14.5mm). As this is the only thick spacer you need to check stud length.
The rod with the plate is called the butterfly rod and was fitted to all Cooper twin carb HS2 set ups.
Accelerator bracket for twin carb models, mounts to inlet manifold.
The proper slot head screw for the SU dashpot and float lid 3/16 whitworth thread.
The metal washer that goes up against the seal on the jet where it enters the float bowl on all HS type carbs
This is the left hand linkage lever that sits on the rods between HS type twin carbs.sold individually
These Swedish made Misab plates are known as the best for mounting your 40/45DCOE carb to its manifold to avoid fuelling problems. Sold singly per gasket
Intake manifold gasket for Arden 8 port head.
4 required.
Gasket for an HS4-carb and manifold .Sold seperately and order as required for your car(usually 3).
Stainless steel twin HS2 heatshields kit. Comes with link bar, bolts, nuts and springs.
Mini Spares own performance upgrsded paper gasket that sits either side of the carb to manifold spacer on HIF38/44 type 1.75" carbs.Sold singly, order quantity as required to suit your car.
This throttle return spring fitted every HS2/4 single SU carb and also on the twins as fitted by the factory. Twin carbs used AEC2075 for choke return. Total length 90mm.
Used in petrol fuel lines to take 1/4" petrol hoses it is used mainly on twin carb set ups for petrol being diverted to the 2 carbs.
Manifold to carb gasket for HS2 single and twin carbs, usually 3 per carb required.