($3.20) £3.20 exc vat
($3.84) £3.84 inc vat
In stock
they fitted from the gearbox to the subframe. When they introduced the twin point in 1996 it was moved to the upper engine stabiliser arm. About 13"LONG.
($3.20) £3.20 exc vat
($3.84) £3.84 inc vat
In stockRecommended usage 1 x 5L1137 to fit one mini.
Wiring loom for rod change reverse light switch.
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
Dip switch lead for left hand drive cars, these are not included with new looms.
Dip switch lead for right hand drives cars, these are not included with new looms.
Mini Mk 4 998 oval centre dash,twin column stalks,rocker switches including rear fog and heated rear window,reverse lights and rear fog lamp is on headlamp circuit. Intertia starter. To go with AN145 rear loom.
mainly for 1980-1...
Main and dash wiring loom except ECU engine harness for SPI Cooper with no dim dip to SN58746, no alarm --no longer available from Rover.
Front loom for 998 Clubman with alternator.
Rear wiring loom for SPI cars. These have bullet connectors to join the front loom, later cars had a multiplug which use YMD10717.
Mk3 loom for 72-75 saloons with alternator, 2 piece (front and rear).
Rear wiring harness for Mini Pickups pre-1979.
Braided wiring loom for 1963-64 1071 Cooper S only, no oil pressure light and longer wires to the voltage regulator box.
Complete with rear loom
Repair loom and plug for all post 1976 headlamp switches.See PM08 for headlamp switch with plug and correct wires colours for loom repair
Auxilary wiring for genuine Rover spot and fog lamps needed when fitting genuine lamps to cars not originally fitted with auxilary lamps or for cars that have had the wiring damaged. This loom is supplied with complete lamps XBN10008 and...
Main wiring loom with dim dip. Fits all 1275 cars with HIF38 carb from 1991-1994. No alarm.
Main and dash loom only.
Front loom only. MK4. Center speedo,inertia starter,rear fog switch.
non ballast coil,last with centre clock
For early Traveller with 3 wire wiper motor and will fit van etc but has extra wires for the temp and oil gauge--dynamo type, complete with rear loom.
SPI with dim dip-fuel injection cars. Just the main loom only, does not include the engine harness or rear loom. With factory alarm.
Cooper and Cooper LE not RSP version although could be used--electic fan wires
different
Main and dash loom only
Harness to ECU for SPI manual models to chassis number BD 059821 has 2 plugs that connect to the ecu.
Rear body harness with speaker wires,known as thin wall PVC type type which replaced the thick wall type in 1989. AN166 is the thick wall early equivalent.
If your car has no speakers just disregard the extra wires. This loom ha...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.