($62.25) £62.25 exc vat
($74.70) £74.70 inc vat
($62.25) £62.25 exc vat
($74.70) £74.70 inc vat
Courtesy switch for MPI minis from 1996 when the wiring was changed from bullet type to spade connection. This is the switch that fitted into the A post to turn the interior light on and off, the earlier switch is no longer available so if you have a...
IGNITION BARREL TO FIT 13H337 SWITCH. MK1/2/EARLY MK3. ONE BARREL,TWO KEYS
MK1/2/EARLY MK3. 3 position spring loaded type. Comes with barrel.
For barrel only use part number 24G1345.
This switch fits under the brake pedal on the floor. See also BMK1903A locknut for this item.
Accelerator pedal rubber pad for Mini pre1976 or Morris Minor.
HAZARD WARNING SWITCH, PIN TYPE CONNECTORS. MK4 FROM 1976. 3.1cm tall.
Rocker switch for Mk2 & Mk3 two-speed wiper motor. Blade connectors.
This part often fails and if the conection points look dodgy replace the socket 520161 which also has a small loom.
Replacement headlight switch as fitted to all models from 1976 until 1997.
Gasket for SPI throttle body spacer. 2 required
Screw for holding PRC1230A to the number plate light body, 1970 onwards.
Basic idle air control valve for spi Mini's. Unlike the mpi stepper motor which uses a bypass valve this unit controls the throttle directly, if you are having issues on idle then 1 or more of the 4 windings could not be working, this is usually due ...
SPI throttle body spacer - the gaskets are available as LZV1101GASKET
A Plus Electronic Ignition distributor with vac unit, modified to our spec in UK to give best performance on any minis with std to 276 camshaft profile.
Ideal for our EVOLUTION001 camshaft
Brand New distributor complet...
Lucas upper lens plus gaskets for cars with built in reverse facilty in lamp
These are the upper lens in clear plastic with 2 new lens gaskets to stop water seeping into the lamps, plus the correct bulbs when you require the fashionable clea...
If you've ever changed a fuel filter on an injection car you may have noticed you need to remove the whole bracket in order to remove the filter as the securing bolt is on the wrong side for good access, this is because the bracket was originally use...