WIRING MAIN LOOM COOPER HIF44 CARB TYPE 1990-91
YMC11428

($249.13) £249.13 exc vat

($298.96) £298.96 inc vat

In stockIn stock
Cooper cars with HIF44 carb from 1990-91 R/H/D with pre engaged starter,side repeater lamps on wings, 3 clock instruments--The Cooper LE(RSP) 1990 model has different loom listed as YMC11388 but this loom has been used by trade customers although not quite correct on fan and thermostatic fan switch.(RSP had a seperate harness for fan).

Has 2 round plugs -One plug with Black/Green and Black/Orange--

the other plug has black/Orange and Black wires--these are for the fan and thermostatic switching.

($249.13) £249.13 exc vat

($298.96) £298.96 inc vat

In stockIn stock

Recommended usage 1 x YMC11428 to fit one mini.
Battery fittings, cables and main looms - Qty 1

Recommended products

A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...

Rear body harness with speaker wires,known as thin wall PVC type type which replaced the thick wall type in 1989. AN166 is the thick wall early equivalent.

If your car has no speakers just disregard the extra wires. This loom ha...

People also bought products

Plug and fly loom for later 2/3 clock speedos, useful if you are converting from a centre speedo to later clocks or just repairing a standard loom.

Rear loom for 1992 on carburettor cars with a 13 way Econoseal plug.

Rear wiring loom for SPI cars. These have bullet connectors to join the front loom, later cars had a multiplug which use YMD10717.

Rear body harness with speaker wires, known as thin wall PVC covered wire type in FROM 1989 and occassionly fitted or found on early cars wothout any problems.



All rear body looms are OBSOLETE from Rover but we can get them made up...

Repair loom and plug for all post 1976 headlamp switches.See PM08 for headlamp switch with plug and correct wires colours for loom repair

Rear body harness with speaker wires,known as thin wall PVC type type which replaced the thick wall type in 1989. AN166 is the thick wall early equivalent.

If your car has no speakers just disregard the extra wires. This loom ha...

You should always use this kit for fitting any auxiliary spot or fog lamps.

Kit contains wiring and safety relay-cheaper than a burnt out engine compartment.

Please note, SPI and MPI cars have this facility built as standard safety ...

All Minis require an earth strap from the engine to the body and from 1959-1996

they fitted from the gearbox to the subframe. When they introduced the twin point in 1996 it was moved to the upper engine stabiliser arm. About 13"LONG.

When replacing the 520160A parking switch the inner contact areas on the wiring loom are also worn or damaged so we produced this socket and small length of loom.

Universal post type battery earth strap with clamp type fitting and correct length for most alternatives of batteries fitted.

The battery cover made of a special cardboard as fitted to all minis to protect

the battery terminals from metal objects. See also the 14A7666 retaining strap.

This is the wiring short conversion loom that fits to the old central speedo and is used by people modifying from 2 or 3 clock dashes to single clock or just repairing damaged looms. With the correct bulb holders and spade fittings. Now uses 5x [link...

A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...

Basically just the rear lamps and number plate lamp wiring loom for mini van.

Large grommet to fit 1"approx holes in bulkhead for items that need to be able to flex and move such as capillary tubes and oil pipes. 7/32" hole size.

The small hole will expand and is also used as wiring loom through bulkhead and battery c...

This plug fits the hole in the inner wing where the wiring for the wing side repeater lamp goes through the body on cars after 1986.

Wiper motor fitting kit to fit all mk2 onwards wiper motors to the bulkhead.

Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls

Brand new modern electronic version of the classic centre speedo, housed in a billet case with OLED display this unit fits as per original speedos. Features include:



*Trip and total miles

*Remote trip reset

*Driv...

Brand new modern electronic version of the classic centre speedo, housed in a billet case with OLED display this unit fits as per original speedos. Features include:



*Trip and total miles

*Remote trip reset

*Driv...