This hose is exact length for the clubman 1000/1100cc range and will need slightly shortening for the first generation MK1 mini radiators where the outlet was on the very end of the top tank instead of 1.5" inward towards centre which is how all radi...
MPI alloy billet thermostat housing. Useful for any radiator fitted in front of the engine this housing has an outlet pipe for the expansion tank.
The original tooling is no longer available and believed scrapped. Supplied with 2 gaskets.
Larger bore at thermostat end requiring larger clip GHC811 Radiator end.
This hose has the standard size bore for the radiator but the thermostat end is larger as fitted to the Carb Cooper from 1990/1 and used the old metro type...
Side mounted as per all pre 1996 cars. UK made with 2 core tubes. V shape fins 20 per inch the BIG Daddy of all rads.
This is a super cool lightweight alloy radiator BUT FOR PRE 1990 cars as it has the overflow pipe facing backwards.
Looks different to other housings with its flatter top, it also has a small outlet which is drilled for expansion tank overflow. It was also used without the drilled hole (PEQ10019)on cooper models from 1990-1 as it offers more flow through its large...
FITS INTO SANDWICH PLATE ON CARB COOPER HAS M8 THREAD 8MM WIDE
Lower Radiator Hose-See C-GRH1159 silicon hose also which is priced to sell.
The lower hose on the late model Mini is VERY different! You've got to have one of these when you need it!!! Typically found on all Minis 1990-1991 wi...
Mini Spares own product,the most complicated hose on a mini yet? If you have a front mounted radiator such as on the twin point injection cars you will have this brainchild of a hose fitted. Hose clips/joiners not included.
MPI SANDWICH PLATE. No hole for radiator bracket although same caasting as other sandwich plates but has a large 12mm threaded hole in the side for the transmitter.
Expansion tank in plastic for Twin point injection cars with front fitting radiator only. Now Back in stock. Don't forget to check the special plastic cap GRC1184 is functioning correctly, it should allow water/pressure to escape from it...
Coolant temprature transmitter fitted to SPi cars from 1992 until 1996. This transmitter is denoted by it's black plastic end. Mounted to the underside of the inlet manifold.
Genuine Mini Spares own product,this top hose is a real large bore hose that goes right across the engine so you cannot miss it on your twin point injected car with a front mounted radiator.
Try the C-GRH1465 silicon hose if you...
Lower spacer tube for the one piece rad cowling as fitted from 1974 on.
the rubber grommets CAM4618 sit on this tube to silence radiator rattle.
T shape special hose for Single point injection cars only, from thermostat to inlet manifold and heater hose-
(221mm)8.75" long on top with the lower bent outlet facing to the left at the bottom, the left top part is (108mm)4 and quarter inc...
Usefull joining union for 1/2" water hoses and used for oil coolers hoses.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.