Special bolt that fits the engine front plate to support the adjusting link for alternators/dynamo

Identical to the GXE1002 competition alternator but with a larger pulley designed to stop over charging the alternator on race cars which spend the majority of time at high rpm. Weight 3.277 kg.

This lightweight alternator is favoured by competition users, new design for 2014 these are now a direct replacement for the original alternator so no additional brackets are required. A small amount of wiring required to fit the Mini wiring loom.

This very trick pulley is machined from billet aluminum & black anodized. It is oversized (5") to reduce the speed of the generator or alternator on high rpm engines preventing over charging the system.

When using this pulley with the origi...

Alternator bracket fitted on the block of earlier Pre A series engine blocks.

For later A plus blocks see CAM4853

The current genuine large plastic shield with all fittings required to cover the engine electrics.

Parts are available seperately:

The plastic clips are 13H6461.

Upper bracket is NJU10002 x 2 requ...

Fitted from 1996 only this alternator sits higher than originally, with new brackets that will only fit the twin point injection cyl head. A1151-65 type producing 65amps (Was GXE2862 from Unipart). If your battery seems to be always running low it mi...

LARGE ALLOY HEAVY DUTY ALTERNATOR BRACKET FOR ALL PRE A PLUS ENGINES(PRE 1980) AS USED ON ABINGDON ST WORKS CARS

Wiper motor fitting kit to fit all mk2 onwards wiper motors to the bulkhead.

Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.

This is the wiring required if you have side repeater lamps on your front wings including bulb holder, grommet and connectors LESS the bulb. The large grommet that sits in the inner wing where the wires go through is YML10654. sold indiv...