£1.50 exc vat
£1.80 inc vat
In stock
£1.50 exc vat
£1.80 inc vat
In stockRecommended usage 1 x 3H1457 to fit one mini.
Clip to retain the speedo cable to the bulkhead on pre 82 cars approx. This clip is also used to hold the loom to the inner wing on some cars.
Dip switch lead for right hand drives cars, these are not included with new looms.
Mini Mk 4 998 oval centre dash,twin column stalks,rocker switches including rear fog and heated rear window,reverse lights and rear fog lamp is on headlamp circuit. Intertia starter. To go with AN145 rear loom.
mainly for 1980-1...
Front and rear loom for 60-62 mini van and countryman, braided with floor start and dynamo.
Repair loom and plug for all post 1976 headlamp switches.See PM08 for headlamp switch with plug and correct wires colours for loom repair
Was HAM3066 main loom less the wing side repeaters but superseded by Rover to this loom with side repeaters on wing,although the manufacturer of these looms always added them to HAM3066 anyway -Inertia starter, Ballast coil, Instrument cluster in fro...
Rear body harness with speaker wires,known as thin wall PVC type type which replaced the thick wall type in 1989. AN166 is the thick wall early equivalent.
If your car has no speakers just disregard the extra wires. This loom ha...
Rear body harness with speaker wires, known as thick wall type which was replaced by thin wall PVC covered wire type in 1989. AN169 is the thin wall equivalent and occassionly fitted or found on early cars wothout any problems.
...
We sell about 20 of these per year and many are used on similar models to those indicated-Main and dash loom only--No side wing indicators-indicator stalk on right-alternator-rear lamps with reverse lights-steering lock-inertia starter-centre speedo ...
You should always use this kit for fitting any auxiliary spot or fog lamps.
Kit contains wiring and safety relay-cheaper than a burnt out engine compartment.
Please note, SPI and MPI cars have this facility built as standard safety ...
Inertia starter -no side repeaters on wing -Instrument cluster in front of driver,either 3 clock with tacho or 2 clock cars but ignore wires from distributor for tacho and tacho wires.
On pre 1984 cars the wiring for the indicator...
All Minis require an earth strap from the engine to the body and from 1959-1996
they fitted from the gearbox to the subframe. When they introduced the twin point in 1996 it was moved to the upper engine stabiliser arm. About 13"LONG.
Originally for mini special 20th edition which had 2 clock speedo cluster in front of driver and AAU3296 (ADO16)wing indicators.The special also had 1100cc engine. This front loom only has found its way on certain mini clubmans with corr...
When replacing the 520160A parking switch the inner contact areas on the wiring loom are also worn or damaged so we produced this socket and small length of loom.
Universal post type battery earth strap with clamp type fitting and correct length for most alternatives of batteries fitted.
The battery cover made of a special cardboard as fitted to all minis to protect
the battery terminals from metal objects. See also the 14A7666 retaining strap.
This is the wiring short conversion loom that fits to the old central speedo and is used by people modifying from 2 or 3 clock dashes to single clock or just repairing damaged looms. With the correct bulb holders and spade fittings. Now uses 5x [link...
1976 facelift type on in PVC for 1275GT only
Instrument pack wires require use of your old wiring block.
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.