£81.00 exc vat
£97.20 inc vat
In stock
This is a cheaper alternatives for the original SU pumps, different to look at and fit but comes with rubberised clamp for easy universal fitting. Made in Germany for excellence it should last longer than the original as it has electronic inners and not points!
These are shorter than the originals (under 5")but have proven very popular with customers not requiring originality. They are slightly slimmer than originals at 1.920"(48.7mm) so for fitment to the original bracket 21A632 extra packing to the rubberACB9252is required.The rubber in the clamp supplied is ideal for extra packing but make sure the pump in firmly fitted.
Negative earth only.
£81.00 exc vat
£97.20 inc vat
In stockRecommended usage 1 x AUF214MS to fit one mini.
Special clip for all our braided s/steel petrol hoses.14mm to 16mm.
Special rubber hose 1/4" bore for use on petrol lines, this is in black and not armour plated outside but does have internal reinforcing. Supplied as pre cut 1m length with 2 clips and is safe to use with modern fuels with higher ethanol content. SAE...
A genuine original S.U. pump ETHANOL tolerant since 2011/2 that will fit into your original mountings with no hassle. Suitable for all cars with electric "pusher" pumps. Replacement points for this are available as AUB6106A.
An...
The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank out before fitting and drive your mini more to avoid water build up.
Replacement pump only for the original WFX100810<...
The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank before fitting and drive your mini more to avoid water build up.
Replacement pump only for the WFX100810 (doesn't...
Mini Spares Non Genuine version mechanical fuel pump. Brilliant aftermarket alternative for cars pre 1990.
Drives off the camshaft at the rear of the motor. These pumps are generally reliable but when a diaphragm goes bad it can be very bad ...
THE ELECTRICAL CIRCUIT FOR THE FUEL PUMP INCORPERATES AN INERTIA FUEL SHUT OFF(ifs) SWITH WHICH WILL STOP FUEL BEING DELIVERED TO THE ENGINE IN THE EVENT OF SUDDEN DECELERATION--It is fitted in the engine compartment, fixed to the bonnet switch brack...
For 1275cc engines after 1990 on with HIF38 carbs.
has a 5/16" (8mm)inlet which makes it unique to this model
The 1990-1 models of the Mini with 1275cc engines and HIF44 carbs use a AZX1817 mechanical fuel pump. Driven ...
Gasket/seal for mounting the fuel pump to tank for SPI and MPI Mini's
Fuel pipe from the fuel filter to engine on spi and mpi models up to chassis no WD169574 when fuel filter GFE7059is fitted.
Tube nut has four threads, the metal pipe has a union on the end that is fatter than the metal...
The 1990-1 models of the Mini with 1275cc engines and HIF44 carbs use this different mechanical fuel pump. Driven off the camshaft at the rear of the motor these pumps are generally reliable but when a diaphragm goes bad it can be very serious as oft...
Points for the original style AUF214 SU electric fuel pump,if the car has not been used for a while these points often stick so you need to give the pump a few careful whacks to help them disengage. If they stick again check them over f...
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
This is...
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orange ...
Special rubber hose 1/4" bore for use on petrol lines, this is in black and not armour plated outside but does have internal reinforcing. Supplied as pre cut 1m length with 2 clips and is safe to use with modern fuels with higher ethanol content. SAE...
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orang...
Original body but with latest solid state electric functions for reliability
see AUF214EP for positive earth type.
Used on Facet range of solid state and silver fuel pumps SS501/2/3 with 1/8" nptf thread size with 1/4" standard fuel line.
Named after its shape there are 2 of these on plastic outlet covers on every SU electric pump and the gasket underneath them is AUB676
The round gasket that sits under the AUB663 plastic outlet banjos on every electric SU pump, also fits under the filter.
Before the days of Aeroquip, the British were making their own braided steel fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. British Length 7.5"...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.