(¥1) £0.70 exc vat
(¥1) £0.84 inc vat
In stock
(¥1) £0.70 exc vat
(¥1) £0.84 inc vat
In stockRecommended usage 6 x 14A7304 to fit one mini.
Boot hinge gaskets and fittings for original type hinges
5/16" UNF THREAD 2 1/2" LONG bolt commonly used for 21A2838 petrol tank strap
Stainless steel version of GFK5184, worth keeping a few spare as they are one of the most common bolts fitted to the Mini.
FIA spec anchor plate for eye bolts, used when fitting harnesses. Sold individually, 7/16 UNF 65x65x3mm.
Screw for chrome metal number plate lamp on mk3 19790 on - You will have to drill the lens out to take M4 screw.
Clutch housing bolt to engine long 5/16" UNC 1.75" long Fitted ffrom 1985 for clutch housing instead of 22A152 stud
Special thread cutting screw 1/4 UNF 1.25" (31mm) long.
Screw to hold the lock assembly on the door of MK3 cars with internal hinges and wind up windows. On new doors or for easy fitment use these special screws with cutting thread (3 sided ...
Clutch housing bolt to engine long 5/16" UNF 1.75" long with tuflock patch to secure. Earlier bolts less tuflock are {link]BH605141{/link}
Self tap screw No10 for holding wiper motor strap to body and any other use.
M10 metric flanged bolt 35mm long for catalytic converter. (4 required per unit)
Wing nut to secure the air filter box on Cooper & Cooper 'S' models.
Mini Clubman front bumper, a very good copy produced from new tooling in a high quality chrome finish.
Remember-all chrome needs regular washing and cleaning as atmospheric filth contaminates modern day chrome,
For rear bumper see ...
New set of metric studs, bolts, nuts and washers as supplied with the alloy external hinge kit (PEASE NOTE: This kit is NOT suitable for the original hinges). The studs have allen key socket ends to help put them into the hinge easily without damage,...
An aftermarket version of the mini bumper in stainless steel it has the original type open ends (Rover curled the sharp edges over) - BUMPER BOLTS ARE FITTED BUT NO NUTS -3 required metric M6 thread nuts FS106047
For top qualit...
Remote type gearboxes had four UNC bolts holding the long alloy housing to the differential case. These are the shorter two, 3/8"unc 1"long. The longer two are ZCS628.
Also the bolt to hold the starter motor.
Also the bolt for the [...
Front subframe to front teardrop mounting, clutch case to block.
Engine mounting to subframe - easier to use than the GFK5184 - 3/4" long
Bolt used in our anti roll bar kit and for holding plate on speedo drive housing on gearbox
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.