Clip to retain the speedo cable to the bulkhead on pre 82 cars approx. This clip is also used to hold the loom to the inner wing on some cars.

Mini Mk 4 998 oval centre dash,twin column stalks,rocker switches including rear fog and heated rear window,reverse lights and rear fog lamp is on headlamp circuit. Intertia starter. To go with AN145 rear loom.

mainly for 1980-1...

Braided Wiring loom for MK1, floor starter with coil on dynamo and temp gauge. 1962-63 approx. 3 clock type

Rear loom for 1992 on carburettor cars with a 13 way Econoseal plug.

Harness to ECU for SPI manual models from chassis number 059822 to chassis number BD 103112 has 1 plug that connects to the ecu.

Rear body harness with speaker wires, known as thin wall PVC covered wire type in FROM 1989 and occassionly fitted or found on early cars wothout any problems.



All rear body looms are OBSOLETE from Rover but we can get them made up...

Double bullet connector used to join the front loom to the rear loom enar the wiper motor.

Auxilary wiring for genuine Rover spot and fog lamps needed when fitting genuine lamps to cars not originally fitted with auxilary lamps or for cars that have had the wiring damaged. This loom is supplied with complete lamps XBN10008 and...

Printed circuit board for 1989 to 1996 3 clock Nippon Seiko type Mini gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.

For early Traveller with 3 wire wiper motor and will fit van etc but has extra wires for the temp and oil gauge--dynamo type, complete with rear loom.