STRAIGHT CUT FIRST MOTION GEAR FOR PRE A+ GEARSET

19 teeth



See table of "Straight Cut Gear Kits" and their components

In 4 synchro gearbox it's a critical part of the close ratio gear set. Be sure to check your old one for wear on the inner surface of the layshaft bearings; it wears out far faster than the gear teeth! Pre A+.For A Plus see C-22A1737A 15...

straight cut reverse gear for the 4 synchro Pre Rod chabge gearbox we use the 16 and 18 teeth pattern for longevity.



See table of "Straight Cut Gear Kits" and their components

Evolution Straight cut 24 tooth input gear.

These gears are banded with 2 rings for identification.

Do not mix and match with other gears that have same teeth counts unless they have the same 2 identification bands


...

Minispares were the first company to produce these layshafts for performance engine/gearboxes as the standard type would flex and resullt in the breakage of the bearings causing seizure. Produced in an upgraded material and heat treated to the correc...

Minispares were the first company to produce these layshafts for performance engine/gearboxes as the standard type would flex and result in the breakage of the bearings causing seizure. Produced in an upgraded material and heat treated to the correct...

Evolution Straight cut 24 tooth input gear. Usually has 2 identification rings on gear teeth.





Achievable drop gear ratios when using our Evolution gears:



22 tooth primary - 30 tooth idler - 25 too...

Left hand differential lock tab as used on rod change boxes up until 1982 when they were not longer used. For R/H locktab see 22A962

Mini Spares genuine part, made for reliability, because the current Rover 22G2033version is not good enough. These specials are CNC grooved for correct shape and machined for concentricity using the original type fixings to get the corr...