Showing 21 to 40 of 299

Clip for holding the choke cable on the HS carb abutment bracket 12G766.

alloy air intake between carb and air cleaner on HS4 SU carbs

The Maniflow steel intake manifold has established the standard by which all others measure themselves. This manifold is specially designed to maximize air flow within the space requirements of a Mini. It accepts either twin 1 1/2" or twin 1 3/4" ...

Identified by its pink band this is for the right or rear carb on twin set ups

as standard on Cooper and S versions--a longer version of feed pipe for twin HS4 carbs is AUD9102



20 degree float ang...

brighten up your engine bay area with these bright alloy carb covers --these fit HIF type carbs only- see R22BLUE and R22 for chrome look

Jet tube for th SU carb: if you have a single carb, this is it; on duals it is for the right carb. Orange band for recognition.

Jet for twin HS6 carbs: The yellow band denotes left side/timing end carb. This is a 100thou jet.

5/16"unc cap head bolts 7/8"long for attaching the air cleaner alloy elbow to the carb on all HS2/4 and HIF.

Complete service kit from "SU" includes all the bits needed for a very complete rebuild of your twin HS2 or HS4 carbs; Carb repair kit less spindle and butterfly -includes float needle valve and jet. Full repair kit see [lin...

Service kit for the following carbs: FZX1306, FZX1307, FZX1280, FZX1281, FZX1409, FZX1412, FZX1429, FZX1433, FZX1462, FZX1524, FZX1526, FZX1525, FZX1531, FZX1469, FZX1312, FZX1366, FZX1422, FZX1428, FZX1443, FZX1468, FZX1529, FZX1419.

If fuel is overflowing the float bowl the needle valve is leaking. This may be caused by the float WZX13040(GSU200) being misadjusted, stuck or leaking OR the needle may be fouled with a bit of grit or worn and not sealing. This is an

altern...

brighten up your engine bay area with these bright alloy carb covers --these fit HIF type carbs only- see R22BLUE and R22RED

brighten up your engine bay area with these bright alloy carb covers --these fit HIF type carbs only- see R22 for chrome look and R22RED

Jet tube for twin SU carb: If you have a single carb, use AUD9098A although some people interchange with this one. This is for the left hand or front carb and identified by a green band.



20 degree float angle.

Every mini with a single HS2 (1.25") carb had this jet fitted..Also denoted by its black plastic base. Twin HS2 and HS4 carbs used the same bore but different lengths and angle on one side. For twins see AUD9141A/2A

Latest design jet fitted to the HS6 carb, it had a metal base rather than plastic and was called a waxstat type.

5" long steel intake manifold by Maniflow for Weber 45 DCOE/DHLA.

stel fabricated 7" long mainifold for the weber 48DCOE

proven to give the best flow of any manifold available

Arrow previous
Arrow next
1 2 3 4 5 ...