5/16" bore petrol/diesel hose which is sold per metre - also useful as hose for emission or evaporate loss control pipes and expansion tank to radiator use. Suitable for ethanol based products such as modern day fuels. 50psi max. R6 spec.
This fitting kit suits all later day 1.25" and 1.5" twin carb set ups where the balance rods between the carbs required are equal length (2.25"), some early carbs had the balance bar with a triangular plate that were a shorter length. The kit has the...
Spacer block between carb and manifold for single HS2 carb. To use on twin carbs the fixing holes need drilling out to size. 7.5mm thick
New Carb Spacer for HS4 carbs with vacuum take off. 7.5mm thick.
Spacer with gaskets fitted for any 4 bolt fitting carb such as HS6 HIF range about 9/16" (14.5mm). As this is the only thick spacer you need to check stud length.
The rod with the plate is called the butterfly rod and was fitted to all Cooper twin carb HS2 set ups.
Accelerator bracket for twin carb models, mounts to inlet manifold.
High quality klinger gasket that sits either side of the carb to manifold spacer on HIF44 type 1.75" carbs or HIF38. Now also sold as PKX100020EVA by Xpart
For a cheaper alternative see 88G429B sold singly.
3.5" long fabricated steel intake manifold by Maniflow for Weber 48 DCOE/DHLA.
fabricated steel 5" long weber inlet manifold for 48DCOE wbere carb
proven to give the best flow of any manifolds available
The proper slot head screw for the SU dashpot and float lid 3/16 whitworth thread.