The 1990-1 models of the Mini with 1275cc engines and HIF44 carbs use this different mechanical fuel pump. Driven off the camshaft at the rear of the motor these pumps are generally reliable but when a diaphragm goes bad it can be very serious as oft...
A cable/ switch under the pedal on Single point injection cars.
Metal petrol pipe with tank union, this is for all estate and van versions with a mechanical pump where a long full length pipe is required. Made in non rust
metal.
For 21A2331 pipe. Before the days of Aeroquip, Minis had braided petrol pipes. They should be used in place of rubber for all fuel lines where possible. This is 5/16" bore size for the joining pipe on twin tanks using the original pipe ...
complete overhaul kit for non turbo HIF44 carb includes needle valve and throttle shaft plus spindle--See CSK75 for service kit less spindle and disc
Fuel pipe from the fuel filter to engine on spi and mpi models up to chassis no WD169574 when fuel filter GFE7059is fitted.
Tube nut has four threads, the metal pipe has a union on the end that is fatter than the metal...
Vacuum pipe that fits to the air inlet pipe on all SPI Models
(Air box underside to air box upperside hot air temperature control valve.)
MLH10022 Which has angled ends,fitted from inlet manifold to...
There are 4 vacuum pipes on the single point injection car. This one fits to the underside of the air box to back of inlet manifold.
MLH10022 Which has angled ends,fitted from inlet manifold to fuel trap.
[link] M...
These were special screws which should be changed when used as they have a securing area on them to stop vibrating loose, as they are no longer available we have had a replacement screw made
Union for fuel filter outlet to fuel pipe on single point injection cars and early MPI (TO WD169573). Requires 2 EDP9976 seals. On later cars the union on the fuel line screws directly to the filter.
complete rebuild kit for Turbo type HIF44 carbs including needle valve and throttle spindle plus disc.With damper clamp ring as fitted to turbo only
This genuine tank from original tooling fits all the long wheel base Minis, except for the very early side-tank wagon. Because of the outside location of these tanks, below the rear cargo area, they seem to take a real beating and should be checked f...
Genuine Weber 45DCOE Carb, calibration from the factory is as below:
Choke 36
Throttle Plate Angle 78 degrees
Auxiliary Venturi 4.5
Needle Valve 200
Main Jet 145 Pump Jet 45...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.