Showing 421 to 440 of 482

Support bracket for the R/H, genuine Heritage part, can also use our own bracket 21A1329.

Not built up-A matching pair of HS2 twin carbs with polished dashpot covers and stainless steel heatshields plus original type twin HS2 linkage kit, inlet manifold but less air cleaners etc.

The UNC bolt holding the...

Small hose clip for 1/4" fuel line (our part number PETROLPIPE)

SPI throttle body spacer - the gaskets are available as LZV1101GASKET

Description

An "ALL IN ONE" fuel treatment providing ethanol protection, lead replacement and an octane improver that adds up to two octane numbers (20 points) to unleaded fuel.

Endorsed by FHBVC to protect against the corros...

Fuel pipe from the fuel filter to engine on mpi models from chassis no WD169574 when fuel filter GFE7057 is fitted.



Tube nut has 7 threads and the metal pipe is the same size with a flared end.

Used on Facet range of solid state and silver fuel pumps SS501/2/3 with 1/8" nptf thread size with 1/4" standard fuel line.

5.5 gallon left hand tank with twist in sender unit.

For all mini saloons from 1964 until 1980 except Elf and Hornet. Also except the 1275GT from 1974 which used the later 7.5 gallon tank which became standard fitment to all mini saloons fro...

The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank before fitting and drive your mini more to avoid water build up.

Replacement pump only for the WFX100810 (doesn't...

5/16" bore petrol hose for injection cars sold in metre lengths.

Resilient to heat,weather and suitable for ethanol in modern day fuels.100psi max.R9 spec.

Also denoted by its black plastic base. Twin HS4 carbs have 30 degree float bowl angles and therefore this jet is easier to fit as it is longer. L/H carb uses AUD9098A std single HS2 jet.



For...

The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank out before fitting and drive your mini more to avoid water build up.

Replacement pump only for the original WFX100810<...

Replacement screws and nylon inserts for the Van, Estate and Pick up petrol tanks.

Basic idle air control valve for spi Mini's. Unlike the mpi stepper motor which uses a bypass valve this unit controls the throttle directly, if you are having issues on idle then 1 or more of the 4 windings could not be working, this is usually due ...

Service repair kit for the HIF38 carb (1.5") fitted to the first HIF38 Metro range and old allegro 998cc and 1100cc

Wynn´s Fuel Stabilizer is an additive for petrol and diesel engines to preserve the fuel when the engine is put out of service during a long time or when the fuel has to remain in the tank during a long time, e.g. petrol in case of LPG engines. Ref. ...