Race spec aluminium fuel tank, foam filled 45 litre capacity, sight gauge, meets appendix K race regulations. Hand made in the UK!
Original 7/16" spring type hose clip as used on later cars (approx 1990 on) for some radiator hoses and fuel lines.
Genuine Mini Spares product. The seal that goes on the neck of petrol tanks as protection against water intrusion and to also to make the hole look neater, so replace them when they crack or shrink through heat. This is the original fatter type as us...
Bolts on the side of the injection body housing to control engine idle speed and air flow from cold start up. The blue socket loom cap fits this unit. This is part of MLZ100090. After fitting the cars ignition needs to be turned on and o...
throttle spindle kit for HIF38 type carbs--the butterfly is available seperately as WZX1387. Mainly fitted to Metro and all Minis with 1275 engine 1991 on
Non-genuine version of the choke cable fitted to the early minis which does
not lock into place like the twin carb version. (see 21A1204).
It was made to work with the single HS2 carb and had only the word "CH...
Non Genuine reproduction tank fits all the long wheel base Minis, except for the very early side-tank travellers. Also used on many kit cars and specials owing to its shape.
Because of the outside location of these tanks, the originals seem ...
Also known as the idle air control valve (IACV). Bolts on the side of the injection body housing to control engine idle speed and air flow from cold start up. The blue socket loom cap fits this unit. This is part of MLZ100090. After fitt...
Non Genuine, fits saloons from 1974 until the introduction of injection.
First fitted to 1275GT in 1974 with 12"wheels and all mini saloons from 1980 on
7.5 gallons or 34 litres capacity and the tank is retained by the single stra...
MPI 7.5 gallon tank has both pump and sender unit holes. Some people use this tank for turbo applications. This tank has the shorter neck with restrictor for lead free fuel nozzles as required by Japan and Germany and uses the thinner neck seal [link...
7.5 gallon tank has both pump and sender unit holes for injection cars only. Some people use this tank for turbo applications however.
5/16" UNF THREAD 2 1/2" LONG bolt commonly used for 21A2838 petrol tank strap
The new adjustable height StayUp® Float is resistant to modern ethanol based Fuels and has a military spec closed cell construction making it puncture proof. The ability to adjust the Float Arm allows for quick and easy minor alterations to Float lev...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.