(96,00 €) £96.00 exc vat
(115,20 €) £115.20 inc vat
In stock
(96,00 €) £96.00 exc vat
(115,20 €) £115.20 inc vat
In stockRecommended usage 1 x TURBO05 to fit one mini.
Gasket/seal for mounting the fuel pump to tank for SPI and MPI Mini's
Paper gasket for either side of the spacer on all mechanical fuel pumps fitted on the rear of engines. The spacer with gaskets fitted is available as GUG705603GM.
this rubber mounting kit helps to dampen the pump ticking noise as well as acting as an earth
Solid state competition fuel pump with 6-00-7.252PSI 25 GALLONS PER HOUR.
Uses FPA 903 union or FP903A if you wish to upgrade fuel line size for extra flow theses are ideal for single HS4/6 or twin SU carbs.Next step up in pump is [link]STS5...
factory original fuel pump resistor for Turbos
Non-genuine version of the choke cable fitted to the early minis which does
not lock into place like the twin carb version. (see 21A1204).
It was made to work with the single HS2 carb and had only the word "CH...
Genuine Mini Spares product. The seal that goes on the neck of petrol tanks as protection against water intrusion and to also to make the hole look neater, so replace them when they crack or shrink through heat. This is the original fatter type as us...
5/16" bore petrol hose for injection cars sold in metre lengths.
Resilient to heat,weather and suitable for ethanol in modern day fuels.100psi max.R9 spec.
complete rebuild kit for Turbo type HIF44 carbs including needle valve and throttle spindle plus disc.With damper clamp ring as fitted to turbo only
Designed to look expensive this 60s look cap fits over the genuine Rover locking cap WLD100660 held on by grub screws. Polished alloy finish similar to the Aston or john Cooper cap it is ultra easy to install and looks fantastic. Flip to...
Fuel or water T piece adaptor
used when upgrading fuel system size on specials from 1/4" to 5/16" or any other modifications
Carb repair kit less spindle and butterfly for single HS4 carbs-includes float needle valve and jet. Full repair kit with spindle etc is CRK227-----for waxstat type see CRK121, This kit is suitable for pre Waxstat (pre 74) Minis only
Float needle valve for turbos fitted with standard HIF44 carb. Larger bodied valve.
Inlet size is 0.096". See also WZX1090 smaller bodied valve HIF6 MG Turbo
jet assembly (0.100") for the HIF44 carb only- see MGM10008 for HIF38(0.090")
Saloon petrol tank retainer clip for the rubber seal on the sender unit which is ARA1502 .Early tanks had 6 screws holding the sender unit in place and used gasket GUG705711GM
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.