(¥16) £16.00 exc vat
(¥19) £19.20 inc vat
(¥16) £16.00 exc vat
(¥19) £19.20 inc vat
Recommended usage 1 x 88G479 to fit one mini.
Round spare wheel clamp with bolt for fitting in the boot to the spare wheel boss as fitted to Mk1 minis. See 88G479 for the boot floor boss that this clamp screws into.
Non genuine double skin MKI boot lid. Always fix your swinging number plate and hinges on for dummy fit and alignment before spraying.
This is the only double skin bootlid avaialble.
The Genuine double skin Mk2 type 8G927...
Non genuine single skin MKI boot lid. Always fix your swinging number plate and hinges on for dummy fit and alignment before spraying.
If you have any doubt about the value of these panels- try having the rust and dents removed fr...
Tank strap bracket welded to the rear of the boot floor which the single diagonal tank strap 21A2838 attaches to.
MKI boot lid manufactured by British Motor Heritage. Always fix your swinging number plate and hinges on for dummy fit and alignment before spraying.
The double skin Mk1/2 type 8G9270 introduced in december 1966 is only availabl...
Non Genuine metal battery box. always going rusty owing to the location of where it is fitted. Requires welding in place and preferably painted or a protective coat. Remember to check if the battery cover, strap and clips need changing. Popular afte...
Not just a skin, but a complete MKI boot lid with inner skin. Lightweight, rustproof and well finished.
The rear doors of the Mini Van and Wagon are the same except on the Woodie were a wood frame is screwed to the sheet metal. The door has a inner and outer skin and should have drain holes in the bottom. When these plug up the resulting rust always ...
BOOT LID MK3 until '88 w/holes for seal retaining clips
The boot floor (trunk of the Mini) has always been an area with a great potential to rust. Not only is it often exposed to battery acid but typically water collects there and rust results. BM Heritage produce a sub assembly from original tooling tha...
Genuine metal battery box. always going rusty owing to the location of where they are fitted. Requires welding in place and preferably painted or protective coat of some kind and remember to check if the battery cover, strap and clips need changing...
The genuine bootlid fitted from 1988 where the seal sits on the car body rather than the bootlid itself. The only difference between this and the earlier BMP339 is that it does not have holes drilled for the boot seal clips.
Non genuine mini boot lid with full skin inner frame. The genuine alternative to this is BMP339 with an open back.
Boot hinge gaskets and fittings for original type hinges
Key barrel set for Mk3 onwards door handles and boot handles.
This kit contains all the floor brackets and mounts required for fitting Minis with 7.5 gallon tank 10/12" wheels or with 165 profile tyres.
The boot board bracket 14A9783 is not included
For 10" wheels with 145 tyres ...
bracket for boot board R/H on 7.7 gallon tank and on both sides for 5.5 gallon tank when 165 tyres fitted
L/H BOOT BOARD BRACKET FOR 7.5 GALLON TANK AND 165 TYRES.