DISTRIBUTOR 123 ELECTRONIC IGNITION WITH VAC A+
C-27H7773

($277.50) £277.50 exc vat

($333.00) £333.00 inc vat

In stockIn stock
The all new 123 Electronic distributor is now available at Minispares. Featuring 16 pre programmed advanced curves built in, a must for any mini with a worn distributor. Full instructions are included with the system. For any A series, A Plus engines with vacuum unit. Replacement cap is GDC123 and rotor arm is GRA123.

'The 123 Distributor can be used with 6 or 12 volt power supplied from

the coil be it ballast resisted or not providing the coil has no less

than 1 Ohm resistance'.

($277.50) £277.50 exc vat

($333.00) £333.00 inc vat

In stockIn stock

Recommended usage 1 x C-27H7773 to fit one mini.
Distributors - Qty 1
Distributors - Qty 1

Recommended products
LUMINITION SILICONE 8MM SUPER BLUE HT LEAD SET
BLS529

100% silcone translucent outer sheath, 8mm lead set with stainless steel wire spiral bound wire giving instant and greater resonance, Kevlar fibre core and a ferromagnetic layer for EMC suppression by Luminition. Top end of ignition lead sets.

($39.00) £39.00 exc vat

($46.80) £46.80 inc vat
COIL FOR NON BALLAST / POINTS IGN UPTO 1983
GCL216

Original mini coil fitted to all cars up to 1983.

3ohms

NOT for ballast type ignition systems.

Our research, sales and feed back shows Intermotor coils to be the best available for the mini.

Original type coil bra...

($17.42) £17.42 exc vat

($20.90) £20.90 inc vat
Alternative products
DISTRIBUTOR 123 ELECTRONIC IGNITION NON VAC A+
C-27H7772

The all new 123 Electronic distributor is now available at Minispares. Featuring 16 ready programmed switchable advanced curves built in as standard, a must for any mini with a worn distributor. Full instructions are included with the system. For any...

($243.00) £243.00 exc vat

($291.60) £291.60 inc vat
People also bought products
VAC UNIT 45d/59d FOR 1275cc
37H8379MS

Fits our 45/59d distributors, 1275cc as fitted to 12G4180 and ADU3825

Along with our distributor manufacturer we have found this to be the best for modern day fuels for all 45 or 59d distributor for 1275cc uses as...

($6.60) £6.60 exc vat

($7.92) £7.92 inc vat
SCREW KIT FOR 45D / 59D DISTRIBUTORS
57H5135

These are the screws needed to fix the condensor, points, base plate and vacuum to 45D and 59D distributors. For 23/25D type see 17H5106

($1.80) £1.80 exc vat

($2.16) £2.16 inc vat
DISTRIBUTOR 65D 90-93 HIF44 CARB COOPER
AUU1536

Electronic Ignition distributor, fitted as standard to all 1300 Carb Cooper models. Also Metro 1275cc engine.

Replacement service items for this are:

Cap GDC156

Rotor arm GRA2143

Should be used with GC...

($80.50) £80.50 exc vat

($96.60) £96.60 inc vat
DISTRIBUTOR CAP FOR 123 ELECTRONIC DISTRIBUTOR
GDC123

If you have a new 123 ELECTRONIC distributor this is the replacement cap.

For earlier 123 distributors please see part number GDC123E.

Rotor arm is GRA123

($21.00) £21.00 exc vat

($25.20) £25.20 inc vat
DISTRIBUTOR 123 ELECTRONIC IGNITION WITH VAC PRE-A...
C-27H7771

The all new 123 Electronic distributor is now available at Minispares. Featuring 16 ready programmed switchable advanced curves built in as standard, a must for any mini with a worn distributor. Full instructions are included with the system. For an...

($277.50) £277.50 exc vat

($333.00) £333.00 inc vat
VACUUM PIPE ELBOW
12B2062

The stock vacuum advance distributor is connected to the carb/manifold by a small rubber joint that in turn is mated to metal line that fits the distributor. If the little rubber connector is deteriorated it could allow a vacuum leak at the carb and ...

($2.25) £2.25 exc vat

($2.70) £2.70 inc vat
DISTRIBUTOR RETAINING CLAMP.A PLUS pre 85
613857A

prong type clamp that bolts to the block and retain the A plus distributor in place--use TAM1671 the bolt is TAM1706

($4.71) £4.71 exc vat

($5.65) £5.65 inc vat
DIST CLAMP PRE A PLUS
501134

This distributor clamp should not be bent; if it is, either you can't get the dizzy all the way in or it won't grip.

($10.70) £10.70 exc vat

($12.84) £12.84 inc vat
CONNECTOR FOR ADVANCE RETARD VACUUM PIPE
12B2095

Straight rubber connector pipe. The standard vacuum advance distributor is connected to the carb/manifold by a small rubber joint that in turn is mated to metal line that fits the distributor. If the little rubber connector is deteriorated it could a...

($0.90) £0.90 exc vat

($1.08) £1.08 inc vat
DISTRIBUTOR SHIELD COVER FOR ELECTRICS LATEST TYPE
BHM1675

The current genuine large plastic shield with all fittings required to cover the engine electrics.

Parts are available seperately:

The plastic clips are 13H6461.

Upper bracket is NJU10002 x 2 requ...

($29.79) £29.79 exc vat

($35.75) £35.75 inc vat
DISTRIBUTOR CLAMP FOR A PLUS DIZZY 85 ON
TAM1671

Prong type clamp that bolts to the block and retains the A plus distributor in place. The screw is TAM1706.

Pre A plus clamp is 501134

($6.00) £6.00 exc vat

($7.20) £7.20 inc vat
IGNITION IGNITOR PACK 23/25D DIZZY-NEGATIVE EARTH
LU142

Electronic ignition conversion. For point type 25/23D distributors Negative earth only. For positive earth systems use LU142AP12.

ONLY use GCL217 coil for ballasted systems (1982 to 1993 998cc) or GCL216 coil for non-ballasted systems DO NOT...

($143.76) £143.76 exc vat

($172.51) £172.51 inc vat
DISTRIBUTOR CAP 45D/59D
GDC136

Fited to Lucas type distributors with 45D body in 1974 until 1990 when electronic type that was held on by 2 screws appeared as oppossed to this clip on this type. If you need a new distributor clip-we have them as GDC136CLIP.

($4.49) £4.49 exc vat

($5.39) £5.39 inc vat
SILICONE LUMENITION LEAD SET FOR JAPANESE AIR CON ...
BLS515

100% silcone translucent outer sheath, 8mm lead set with stainless steel wire spiral bound wire giving instant and greater resonance, Kevlar fibre core and a ferromagnetic layer for EMC suppression by Luminition. Top end of ignition lead sets.

($40.50) £40.50 exc vat

($48.60) £48.60 inc vat
PERFORMANCE 8mm PLUG LEAD SET RED
C-27H7779RED

Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...

($13.19) £13.19 exc vat

($15.83) £15.83 inc vat
CONDENSER 45D/59D RESIN TYPE ORIGINAL
GSC110

original Lucas type RESIN BASED CONDENSER made for the 45/59D type distributor if you want a quality item rather than the cheaper inferior parts available. Filled with 3m of winding inside as per original Lucas but every copy analysed to date has ...

($7.50) £7.50 exc vat

($9.00) £9.00 inc vat
COIL BRACKET 1969-95 LUCAS TYPE COILS STAINLESS ST...
12G2994SS

Stainless steel coil bracket for 1970-1996 cars.

($9.45) £9.45 exc vat

($11.34) £11.34 inc vat
COIL BRACKET 1969-95 LUCAS TYPE COILS
12G2994

Coil bracket fitted to end stud of cylinder head,clutch end for coil to mount on as fitted 1969-94-MK3 on. This has been made to the original specification with the welded lug nuts rather than the cheaper method of having just plain holes to take a b...

($8.48) £8.48 exc vat

($10.18) £10.18 inc vat
COIL ORIGINAL SPORTS GOLD PERFORMANCE TYPE
MSC105

Best on the market, sports coil-Not Lucas. A standard coil can only do so much, and when compression is raised (as in most high performance engines) or improper fuel mixtures occur something better is needed. This sports gold coil with proven origina...

($20.70) £20.70 exc vat

($24.84) £24.84 inc vat
DISTRIBUTOR ELECTRIC EVOLUTION FOR 285-296 CAMS
C-27H7702

Electronic Ignition distributor, with vac unit modified to give better performance on any minis with 285/286/296 camshaft profiles

Brand New distributor complete with electronic conversion already fitted.

A PLUS ONLY

Replac...

($82.50) £82.50 exc vat

($99.00) £99.00 inc vat