($228.69) £228.69 exc vat
($274.43) £274.43 inc vat
In stock
($228.69) £228.69 exc vat
($274.43) £274.43 inc vat
In stockRecommended usage 1 x GXE1002 to fit one mini.
This is the plug that fits all Mini alternators, except MPI. The three conections are alternator output, 12 volt sense and ignition lamp. Ideal when converting from a dynamo.
This very trick pulley is machined from billet aluminum & black anodized. It is oversized (5") to reduce the speed of the generator or alternator on high rpm engines preventing over charging the system.
When using this pulley with the origi...
Special bolt that fits the engine front plate to support the adjusting link for alternators/dynamo
Alternator bracket fitted on the block of earlier Pre A series engine blocks.
For later A plus blocks see CAM4853
High output, uprated to 70amp (from 45 and 55amp) alternator as used on 89 on model Minis.
Will fit most Minis from 1980 until 1996, except some aircon models (requires transfering the old twin belt pulley to new alternator - see ...
Alternator bracket for A Plus engines and Pre A+ engines with dynamo fitted. See 12G1053 for earlier Pre A plus alternator bracket.
Brand new 45 amp uprated alternator without any surcharges comes with the pulleys fittted which are worth over ten pounds retail. This will cope with all those extras you might have bolted on such as spots and music systems.
Replaces the ori...
The adjusting link bracket for dynamo and alternator that fits on the 12G289 pillar.
The smallest pre engaged starter motor available for the A series yet still producing 1.3KW of power! Ideal for race/tuned cars with high compression and cars that need more room for oil coolers etc. See GXE1004EVO for inertia.
Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls
rear stop and tail lamp for early BMc cars with red plastic lens.
Also stocked is a white lens and single filament bulb equivalent for use as reverse light on kits cars and Mokes as CHM13REVERSE.
Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...
Small battery cable retaining bracket bolted at the front of the engine for pre engaged manual cars approx 1985 onwards.
Lightweight higher power version of GXE1005 (1.6KW as apposed to 1KW), ideal for race/tuned cars with high compression and cars that need more room for oil coolers etc. See GXE1004RACE for inertia.
Lightweight higher power version of GXE1004 (1.6KW as apposed to 1KW), ideal for race/tuned cars with high compression and cars that need more room for oil coolers etc. See GXE1005RACE for pre engaged.
Negative earth only-45D electronic distributor with vac for 1275GT and any pre A Plus 1300cc engine including Sprite and Midget in line engines-
For best performance and tune we advise our electronic Evolution version C-27H7698<...
Range of distributors with modern day curves specially built,programmed and tested for Mini Spares in UK.
Beware of the cheap China made units that we have tested and currently offered by other vendors that are poorly made with wrong setting...
Resistor for AFU3389LED and AFU3389WLED, this is needed to enable the lamps to function properly. Sold in pairs.
These performance road type distributors are for A Plus engines and can be fitted with points or LU143A ignition pack can be fitted as an extra
For best performance and modern day fuel/camshafts and tune we advise our electronic evolution v...
Stainless steel coil bracket for 1970-1996 cars.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.