($8.90) £8.90 exc vat
($10.68) £10.68 inc vat
In stock
MLH10022 Which has angled ends, fitted from inlet manifold to fuel trap. PHP10027 air box underside to airbox hot air control valve. PHP10043 airbox underside to inlet manifold. NPC10001Fuel trap.
For single point injection cars only.
($8.90) £8.90 exc vat
($10.68) £10.68 inc vat
In stockRecommended usage 1 x MLH10026 to fit one mini.
This is the original type of needle valve that governs the plastic fuel float in your SU carb.
An alternative better upgraded version is available as CA90.
Gasket for SPI throttle body spacer. 2 required
The new adjustable height StayUp® Float is resistant to modern ethanol based Fuels and has a military spec closed cell construction making it puncture proof. The ability to adjust the Float Arm allows for quick and easy minor alterations to Float lev...
5/16" UNF THREAD 2 1/2" LONG bolt commonly used for 21A2838 petrol tank strap
7.5 gallon tank has both pump and sender unit holes for injection cars only. Some people use this tank for turbo applications however.
Non Genuine, fits saloons from 1974 until the introduction of injection.
First fitted to 1275GT in 1974 with 12"wheels and all mini saloons from 1980 on
7.5 gallons or 34 litres capacity and the tank is retained by the single stra...
Also known as the idle air control valve (IACV). Bolts on the side of the injection body housing to control engine idle speed and air flow from cold start up. The blue socket loom cap fits this unit. This is part of MLZ100090. After fitt...
Non Genuine reproduction tank fits all the long wheel base Minis, except for the very early side-tank travellers. Also used on many kit cars and specials owing to its shape.
Because of the outside location of these tanks, the originals seem ...
Non-genuine version of the choke cable fitted to the early minis which does
not lock into place like the twin carb version. (see 21A1204).
It was made to work with the single HS2 carb and had only the word "CH...
Bolts on the side of the injection body housing to control engine idle speed and air flow from cold start up. The blue socket loom cap fits this unit. This is part of MLZ100090. After fitting the cars ignition needs to be turned on and o...
Genuine Mini Spares product. The seal that goes on the neck of petrol tanks as protection against water intrusion and to also to make the hole look neater, so replace them when they crack or shrink through heat. This is the original fatter type as us...
Original 7/16" spring type hose clip as used on later cars (approx 1990 on) for some radiator hoses and fuel lines.
Basic idle air control valve for spi Mini's. Unlike the mpi stepper motor which uses a bypass valve this unit controls the throttle directly, if you are having issues on idle then 1 or more of the 4 windings could not be working, this is usually due ...
Replacement screws and nylon inserts for the Van, Estate and Pick up petrol tanks.
The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank out before fitting and drive your mini more to avoid water build up.
Replacement pump only for the original WFX100810<...
5/16" bore petrol hose for injection cars sold in metre lengths.
Resilient to heat,weather and suitable for ethanol in modern day fuels.100psi max.R9 spec.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.