£513.80 exc vat
£616.56 inc vat
£513.80 exc vat
£616.56 inc vat
Recommended usage 1 x FZX3003 to fit one mini.
5/16"unc cap head bolts 7/8"long for attaching the air cleaner alloy elbow to the carb on all HS2/4 and HIF.
Gasket for an HS4-carb and manifold .Sold seperately and order as required for your car(usually 3).
This is the original type of needle valve that governs the plastic fuel float in your SU carb.
An alternative better upgraded version is available as CA90.
This tool/gadget allows you to balance both air intakes on either twin SU or twin choke carbs so they flow exactly the same to give better performance and economy.
Fitted to HIF38 and HIF44 carbs, ethanol tolerant product. Bigger bodied valve.
For turbo models see WZX1095 .Quantity required-1
Float needle valve for turbos fitted with standard HIF44 carb. Larger bodied valve.
Inlet size is 0.096". See also WZX1090 smaller bodied valve HIF6 MG Turbo
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
This is...
Special rubber hose 1/4" bore for use on petrol lines, this is in black and not armour plated outside but does have internal reinforcing. Supplied as pre cut 1m length with 2 clips and is safe to use with modern fuels with higher ethanol content. SAE...
Known as a swinging needle because they sit on a spring which locates into the hat/cup end of the needle and have sideways movement. They start with part number prefix CUD for HS type carbs--NZX for HIF carbs--the earlier H and HS type were fixed sol...
Our heavy duty throttle cable is superior in many ways.
A nylon interior ensures smooth operation. The outer cable is 32mm longer and inner is 95mm longer than the standard one.
Cable to carb bolt is ACC5062.
Clip on the heater valve for heater cables on vehicles from 1990 where the in line remote heater valve was used. It has also been used as a clip for HIF carbs to hold the cable but the one from Rover is 13H3472.
This needle is richer than used in our stage one kit but is useful when slightly different mods are carried out.
A very usefull tuning needle for single and twin carbs when camshaft change for carbs with floating needles.