A very usefull tuning needle for single and twin carbs when camshaft change for carbs with floating needles.
This needle is richer than used in our stage one kit but is useful when slightly different mods are carried out.
If you have fitted our inlet and exhaust manifolds plus an RC40 exhaust to a stadard 1275cc engine this needle in a HIF44 carb will work great if coupled with a K&N pancake filter.
Clip on the heater valve for heater cables on vehicles from 1990 where the in line remote heater valve was used. It has also been used as a clip for HIF carbs to hold the cable but the one from Rover is 13H3472.
Our heavy duty throttle cable is superior in many ways.
A nylon interior ensures smooth operation. The outer cable is 32mm longer and inner is 95mm longer than the standard one.
Cable to carb bolt is ACC5062.
This kit for the HS2 type carb includes the fixed needle type bearing jet(sleeve)the adjusting nut,spring and locknut where you adjust your carbs.
.Quantity required for single carb-1 set or for twin carbs 2 sets required
This is the original type of needle valve that governs the plastic fuel float in your SU carb.
An alternative better upgraded version is available as CA90.
Gaskets and spindle/float lid seals for all the HIF38/44 range.
For HIF38 service kit see CSK94 for mini and CSK78 for metro
for HIF44 see CSK75[/lonk] except turbo
[link]CRK167 rebui...
spindle and parts only required to refurb your HIF38 carb- for butterfly see
WZX1387
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orange ...