(¥4) £3.90 exc vat
(¥5) £4.68 inc vat
In stock
(¥4) £3.90 exc vat
(¥5) £4.68 inc vat
In stockRecommended usage 1 x 22A271 to fit one mini.
Fitted in the gearbox remote control this half moon seal butted up against the gearbox remote housing. The big large plug the other end is 22A271.
For all rod change gearbox mechanism housings, this as un uprated poly bush replacement for the standard rubber bonded mount
The pin in the bottom of your gearbox that holds all the gearchange levers.
These parts are soiled but usable as they are used.
Quick release rod change gear coupling a direct replacement for the standard item, doing away with the troublesome roll pins. It comes complete with high quality quick release clips
Gear lever button for bottom of gear lever in early remote change cars 1961-64.
Just because you have a rod-change gearbox doesn't mean you're immune from gearlever vibration. The ball on the end of the lever wears and is not seperately replaceable; replacing the lever is the answer.
Bias spring arrangement fits the shift rod on rod change cars to "bias" the shift lever towards the 3rd gear gate. Used as standard on our 5 speed gearbox to bias the gear changes also. Tightens up all the linkage and makes gear changes feel easier a...
Oversize cotton reel type mounting, sold singly 2 of these are required on the metal bracket that holds up the rod change gear linkage.
This pin joins the gear change rod to the selector rod, behind the diff housing
case and is usually easier to remove when reverse is selected.In reverse gear the angle is easier for removal. This is a great time to fit the Mini Spares slick ...
Metal coupling sleeve on the rod change gear change shaft extension rod under the floor, which attaches to the gearbox and held on by RPS1416 roll pin. This attaches to the rod that goes to the gearlever housing to change gears.
High quality version of 13H9513, INA branded.
Dual use bearing fits the end of the A Plus 18mm mainshaft where the 1st Motion shaft slides on, plus it is used on the A Plus layshaft smaller end.
Kno...
Upgraded Viton version of ADU5738. Drive shaft oil seal or diff output shaft oil seal for all Mini's except Cooper S and early Automatics. 2 required per gearbox.
IKO idler gear bearing with special rollers for allowing movement on late type idler gears. The idler gears for twin point cars were also made from clean steel as an upgrade from 1996 on. This special bearing replaces the cheaper inferior earlier bea...
Change speed lever on gear change shaft for remote and magic wand type gearboxes
stamped 2A3358 and MOWOG on back
The Swiftune classic Mini Quaife ATB Automatic Torque Biasing differential offers the benefits of an LSD limited slip differential but saving you money on crownwheels and pinion plus output shafts!!
The Swiftune Quaife ATB avoids the need fo...
Kit which enables you to fit a rod change gearbox to an earlier round tunnel.
Secondhand (used unit)only. This sits under the 28G251(DAM8488) alloy housing where the speedo cable connects to on the gearbox and the speedo drive pinion slots through this.Obsolete from Rover we are offering these old used units in ca...
Fits all minis except Autos and those with hardy spicer joints. It has the detent lug on for rod change R/H side. Sold singly.
These might be marked as 22G420 on the casting but they have the correct size bush and seal hole for...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.