This liner was found on many deluxe Minis. The black fiberboard is held on by chrome screws and upholstery washers. Put it on any year Mini.
Manual windshield washer pumps were the norm in the 60's. The pump works on a simple internal diaphragm to create pressure for squirting the water. When connected with the correct diameter (small) hose it provides more than sufficent volume and pre...
This screw fits G283 handle. Also GAM215 mirror and C-AJJ381 bonnet strap.
These heavy duty bonnet pins 4" long and 1/2" thick are favoured by competition car owners to stop the bonnet accidentally coming up. They will require drilling holes in your bonnet and sold in pairs only.
For competition use these pins are the only sure way of holding your bonnet down in place
Genuine R/H rear quarter outer skin from the B post back for MK3 cars with wind up windows.From below the rear side window down, including the lip that the rear quarter light window seal sits on but does not include the inner stifener waist rail [lin...
promotional sticker to advertise your favourite mini parts supplier who just happens to be the largest in the world bar none-Word MINI SPARES in black with love heart emblem in middle on clear background as external sticker
promotional sticker to advertise your favourite mini parts supplier who just happens to be the largest in the world bar none-
Quality UK made with laser cut out air vent holes. Since June 2014 they have been re-designed and made in Marine grade EN5083 grade alloy with improved hardness to fit Heritage and genuine subframes perfectly, it is paramount that that the gearbox cl...
Original BMC rosette emblem sticker fot the inside of your windscreen.
These are water transfers, soak the item in water until the decal slides from the backing, slide onto your work peice and carefully squeeze out water.
Used on all MK1/2/3 bootlids where there are 26 little holes drilled around the inner edge. These are for use with 14A6585 seal--- Later cars 1988 on fitted a seal to the body only (cke10018).
Seal for glass that fits both rear doors on vans/estates. The reason for changing these every few years is that if they leak the water runs into the doors causing excessive rust.
These alloy/aluminium 'polka-dot' kick strip plates were originally fitted to the MKI Mini to protect the door seals and to hold them against the body.
Metal backing plate rear number plate for vans/estates, has location holes for wires of 2 rear number plate lamps at either end - will only take original size number plates as it is only 4.25" high but about 25.25" long to accept the lamps either end...
Genuine panel that has the holes for wipers and jets with only a few inches of pillar which is basically the area that rots. Also referred to as the windscreen scuttle lower panel. Fitting the genuine type ensures you should get a better windscreen a...
Heavy duty bonnet pin kit, contains a pair of pins AND all the mounting hardware.
The original T shape boot handle as fitted to the bootlid of MK1/2 plus vans and estates except the wooden variety....
uses the ADA3817 type of seal, hole will need cutting to suit the shaft of the handle
Upper double row channel for the rear sliding windows on clubman estates
Heavy duty s/steel bonnet pin kit, contains a pair of pins and all the mounting hardware.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.