Showing 1101 to 1120 of 1206

Lightweight aluminium headlamp rim, these are polished and anodised for protection. Will fit all years except mpi cars.

Clubman estate half floor front to rear with inner & outer sills 1974 on L/H

Clubman estate half floor ront to rear with inner & outer sills 1974 on R/H

Stainless steel stud for original production factory fitted sports pack arches.

These use FN105047 nuts.

New genuine arches now have an upgraded threaded brass insert and now use a stud ZUA000250.

Complete set of R/H and L/H metal window frames for Mini Traveller, Countryman and estate models. All in part sections requiring assembly, with corner section inserts to reinforce 4 main strips, plus 8 fitting studs per side.

This is the onl...

Non genuine MK1/2 full floor pan less x member, front to rear with inner sills only --For van/estate see 24A604

This floor is 4 vent sill with round tunnel only for the MK1/2 but you will have to cut and shape the gear lever hol...

Mini bootlid inner frame, useful for racers using an aluminium boot skin.

Re-manufactured obsolete part now available to purchase. This is an item that often gets overlooked when rebuilding the doors. It accepts the screws that retain the nylon door guide dovetail. The drain tube also passes through it. Made from steel wit...

check strap arm in mild steel for the rear doors of countryman,estate and van.

Non Genuine only and only sold as a pair. Genuine were made obsolete early 90's

Crossmember to inner wing bracket bracket for Mk1/2 R/H

not mini clubman

Crossmember to inner wing bracket bracket for Mk1/2 L/H

not mini clubman

High quality non genuine door check strap for MK3 cars with wind up window doors (use with retaining pin CLZ412). Beware there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly!

Curley carbon fibre Mini Miglia wheel arches, approximately 4.8." wide, with front edge 6.9" at widest point. Requires MS127FK brackets. Probably the largest wheel arches used on minis. Set of 4.

Upper door moulding rivet for Cooper S door trim. For Mk1 usually 1 at front and 3 at back making 4 per side and on Mk2 there were 2 per end at bottom making 4 per side. This is the 10mm head rivet and not required on our own 14A9773/9774 trims that ...

Outer skin only without any fitting facility, used mainly by motorsport competitors or for specials where the method of fiting and retaining the bonnet by pins or straps is upto the individual.

Genuine R/H rear quarter outer skin for Cabriolet models.

Genuine L/H rear quarter outer skin for Cabriolet models.