Showing 1081 to 1100 of 1206

MK3 Door & boot handle fitting kit, including original type screws, star washers and gaskets.

The gasket that sits behind the door stiker on all wind up window type minis

on the B post.

Captive nut plate that sits behind the damper bracket on the inner wing/bulkhead to attach the damper brackets. 2 PER SIDE.

Outer skin only without any fitting facility used mainly by motorsport competitors or for specials where the method of fiting and retaining the bonnet by pins or straps is upto the individual. This has the bonnet moulding lip so the grille upper surr...

MkI aluminium boot lid "skin only" panel. This panel is produced off the original tooling, ensuring good panel fit and integrity. Following the pressing of the panel it is hand finished by Heritage craftsmen, to ensure the highest panel quality.

Mini MkI aluminium door skin panels. These panels are produced off the original tooling, ensuring good panel fit and integrity. Following the pressing of the panel it is hand finished by Heritage craftsmen, to ensure the highest panel quality.

Mini MkI aluminium door skin panels. These panels are produced off the original tooling, ensuring good panel fit and integrity. Following the pressing of the panel it is hand finished by Heritage craftsmen, to ensure the highest panel quality.

This is small plate that welds into the later lower dash rails to convert them to mk1 size for people who want early switches in a late car.

Large blanking grommet for the Clubman inner wings, 1.5".

Floor pan for Mini van/estate with no x member for remote change gearbox. Non Genuine. For saloon see 14A6491

picture is just to show what you get but bulge on centre tunnel for starter button appears to be on wrong side as this...

Rear handbrake bracket. 1976 onwards for single cable lever. Welds to tunnel. Not included on CZH2669 floor. For forward bracket see CZH3214.

Genuine Mini Spares Mk3 window drop frame in stainless steel. Supplied with the rubber seal.

Genuine Mini Spares Mk3 window drop frame in stainless steel. Supplied with the rubber seal.

Rear subframe mounting stiffener panel R/H with holes for subframe mounting to wheel arch. Sits on ALA5524 or ALA5528

Rear subframe mounting stiffener L/H repair bracket with holes for subframe mounting and attaches to wheel arch Fits on ALA8623

Mini Spares own MK3 Window drop rail kit includes 1 x ALA5746SS AND1 x ALA5747SS plus 2 x 24A948 seals for the drop rails to hold the glass, this kit will do one complete door only.

Fluted type equivalent of GZF105A. This is equivalent

design of CZH4316 which was fitted between mini special black arches. Sold per side.