Clip on the heater valve for heater cables on vehicles from 1990 where the in line remote heater valve was used. It has also been used as a clip for HIF carbs to hold the cable but the one from Rover is 13H3472.
Our heavy duty throttle cable is superior in many ways.
A nylon interior ensures smooth operation. The outer cable is 32mm longer and inner is 95mm longer than the standard one.
Cable to carb bolt is ACC5062.
Sponge like cushioning seal for all minis between the tank neck and the body plus the minivan/estat/pickup petrol tank where it goes between and tank and the the floor/shroud.
This kit for the HS2 type carb includes the fixed needle type bearing jet(sleeve)the adjusting nut,spring and locknut where you adjust your carbs.
.Quantity required for single carb-1 set or for twin carbs 2 sets required
This is the original type of needle valve that governs the plastic fuel float in your SU carb.
An alternative better upgraded version is available as CA90.
Gaskets and spindle/float lid seals for all the HIF38/44 range.
For HIF38 service kit see CSK94 for mini and CSK78 for metro
for HIF44 see CSK75[/lonk] except turbo
[link]CRK167 rebui...
spindle and parts only required to refurb your HIF38 carb- for butterfly see
WZX1387
Carb repair kit less spindle and butterfly for twin HS6 carbs-includes float needle valve and jet.
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orange ...
Silver top standard 4.0 to 4.5psi, 18 gallons per hour ideal for high output engines using a twin choke carburettor such as Weber and Dellorto with chokes upto 45mm, plus all single SU carbs, plus most twin SU set ups. 1/8" nptf threads and uses 1/4"...
Known as a swinging needle because they sit on a spring which locates into the hat/cup end of the needle and have sideways movement.They start with part number prefix CUD for HS type carbs--NZX for HIF carbs--the earlier H and HS type were fixed soli...
Original classic looking Monza non locking ALLOY cap with the mounting collar to fit tank included.See MONZA also for description
To fit the collar for this cap you will require 10mm(0.3937")just over 3/8" of petrol tank neck ac...
Manifold absolute pressure sensor. MAP sensor
converts pressure variations in the inlet manifold and feeds ECU with information--This part also has the part number on a white sticker for easy identification--THE WHITE PLASTIC SOCKET LOOM CAP...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.