Reproduction version os ASJ360070. For the twin point only as it changed shape to accommodate the front mounted radiator and different bonnet fittings.
The L/H outer door moulding and seal for cabriolet versions. Mini spares usually manufacture these to order as there is no demand -usualy takes 4-6 weeks maximum
The black plastic safety end goes to the front of the car and the rear cut end ...
A Non genuine item but this is the only option available and fairly good quality. A rear valance with the long side pieces makes this panel unique to the Riley Elf and wolseley Hornet only. Floor sections are not available and this rear valance is on...
Really a built up half front end for the mini clubman, consists of a lower panel with headlamp panels,slam panel and stiffener between the front and slam panel. 76 ON--no inner or outer wings
Complete non genuine floor pan assemby with crossmember--
This floor is 4 vent sill with round tunnel only for the remote type gear change vehicles only. We can supply to order the floor for early MK1 magic wand type gearlever if required pl...
Non Genuine for the Pick-up and Van 1964-75 with a slat type fixed grille as a trademark for Mini commercial type vehicles originality.
This panel has the brake cooling cut outs on corners.
Earlier models 1961-64 had no cooling cut...
This inner wing with A panel and door stiffener check strap panel attached for ease of fitment and alignment.No radiator cooling fin slots or the round hole for electric fans and therefore is only suitable for cars with the front mounted radiator, su...
This Non genuine pattern panel has the holes for windscreen wipers and jets with barely an inch of pillar.
On cars from 1992/3 on check the original windscreen drain channel as the VIN numbers were stamped above the clutch master cylinder-wi...
In 1996 when Rover fitted the front mounted radiator they had to change the bonnet design moving the safety catch and bonnet release pin locating area. Otherwise it looked the same.
The UK cars had the bonnet safety catch in the middle where...
This screw can used to hold together the 2 halves of the disc shields on all
mini front discs. fits MK1/2 door escutcheons.
Use SE910161 and cut down to 3/8" long including head
PMZ306 was originally 3/8"long u...
The front bumper of your Mini should be mounted to this simple 'L' bracket that should in turn be spot welded to the lower edge of your front panel. Often damaged in accidents with the bumper. If you replace the entire front panel of the Mini it incl...
Lower parcel shelf facia panel with hole for switch panel that sits between the A posts. This is made to fit Mk3 cars from 1970 onwards with soft trim moulding.
see also 14A7175 for the retainer that welds to the top
SPECIAL 6/32" UNC COUNTERSUNK POZI SCREW 1/4" LONG FOR HOLDING THE 14A6835 BUFFER PLATE TO BODY.
Special 6/32" UNC countersunk Pozidrive head screw 3/4" total length for holding the white nylon door buffer 14A6833.
A post inner closing panel/siffener plate R/H external hinge cars.
Not always stocked owing to lack of demand but available to order.
A post inner closing panel/siffener plate R/H-external hinge cars
Not always stocked owing to lack of demand but available to order
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.