Powder coated finish for longevity and looks. Don't forget to renew the bushes and bolts. These are pre 1990 Non Genuine subframes without the prongs for the later rubber exhaust. Adaptor brackets are available as C-ARA670/1 to enable fitment of late...
Original MK1/2 shape Windscreen washer cycle type bottle clip, about 1964 on.
Has yours disappeared, or just disintegrated with age?
The original winguard MK1 bottle part number was ADA3833 NOW 17H2536 for MK1/2.
<...
Mk3 on Mini (all internal hinged models) inner door frame bottom drain hole repair section with outer skin lip for the L/H door, also see part number MS34L for the repair for the bottom of the door.
Technically you cannot fit b...
Mk3 on Mini (all internal hinged models) inner door frame bottom drain hole repair section with outer skin lip for the R/H door, had 3 drain holes also see part number MS34L for the repair for the bottom of the door.
Technicall...
Stiffener for inner sill for Van with metal load floor and Pickup L/H
The first panel up towards the dash after the floor pans, at an angle and where steering rack bolts to floor without any brackets or fittings, see also same panel with steering rack fitting AHA36006 for 1976 on rubber mounted subframe or...
full inner Right hand wing with wheel arch panel plus the A panel fitted for ease of fitment and alignment for the Mini Clubman with radiator air slats-see also CZH3062 and CZH414
Not usually a stock item but available to order
full inner left wing with wheel arch panel plus the A panel fitted for ease of fitment and alignment for the Mini Clubman with radiator air slats-see also CZH3063 and CZH569
This stainless steel plate has recessed holes in for the check strap screws.
2 per door are required and these are only for cars with external hinges that had the material check strap as per MK1.2 and vans
Minispares 2 piece plastic roof moulding kit specially shaped for the corners and drain holes as fitted from 1980on in black.
The 2 joining and finishing clips are DBE10006PMD which need to be ordered seperately. The last Rover...
Support bracket for the R/H, genuine Heritage part, can also use our own bracket 21A1329.
This is a Non genuine L/H outer MK3 door skin in lightweight Aluminium
It does not fit as well as the genuine CZH3301 but a good inexpensive replacement less mirror holes. Nearly 3kg lighter than the standard doorskin.
This is a Non genuine R/H outer MK3 door skin in lightweight Aluminium
It does not fit as well as the genuine CZH3300 but a good inexpensive replacement less mirror holes. Nearly 3kg lighter than the standard doorskin.
Lightweight Mk1/Mk2 alloy doorskin. Nearly 3kg lighter than the standard doorskin.
Lightweight Mk1/Mk2 alloy doorskin. Nearly 3kg lighter than the standard doorskin.
Roof gutter trim clip in stainless steel, ideal finishing item for our MT632 roof gutter trim.
This very heavy duty bonnet strap is a excellent reproduction of the original factory Special Tuning department special. A copy of our Tan leather strap, but now available in black.
3.3mm thick from the tanneries for use on horse bridles,wit...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.